|Topic Review (Newest First)|
|10-29-2007 05:21 PM|
|Zanshin||Addendum - now that I think about it, all of the 43's that I've seen have had in-mast furling. That is what I have on mine, and since I don't race the loss of performance isn't relevant to me but the ease of deployment and reefing is.|
|10-29-2007 05:19 PM|
I have the manual in front of me, but all I have for the "Classic Mast" is:
Mast Length 50"9'
I am sure that Doyle and Quantum sailmakers have the relevant information in their databases, since (in the Caribbean) they seem to be the major sailmakers for the Jeanneau boats.
|10-29-2007 01:49 PM|
Cruising direct, FX sails, both have online sizes for many sailboats.
Otherwise, personally, I would talk to nearest sailmaker/rep to your boat, then have it measured and go with recomendation. If you main is anything like my 85 Jeanneaus main, I can increase the size by some 20%, as it was ade a bit on the small side as far as leech, and foot measurements, and I can increase the roach a bunch too. Not sure if these performance inhancments are what you want, vs just a robust sail......again, talk to a local sailmaker for best info.
|10-29-2007 12:52 PM|
Sun Odyssey 43 Mainsail
I would like to get a fully battened main for my 43'.
1. Can anyone tell me the correct sail size or point me in the direction of a database.
2. Its for charter use so need a robust ball bearing car system, Frederickson now owned by Ronstan. Are there any USA made equivalents?
Advice on cheapest source.
Any other advice/recommendations?