The current issue of good old boat has an article on this.
09-12-2008 12:15 PM
We have our 41OI in glades,very helpful folks. Call Don Shuler about your cutless bearing. 941-744-6503. He's in Port Labelle. They are good people. If you see them tell them Sea Dancer set ya.
Good luck Steve
09-12-2008 10:47 AM
Thanks guys...and as a former infantry Marine, profanity is not a problem!
09-12-2008 08:17 AM
IIRC, Cutlass was a brand of cutless bearings and typically, it is accepted spelled either way.
09-12-2008 08:15 AM
I just replaced my cutless bearing (it's cutless and not cutlass so I've been told). It can be a royal PITA if you don't have a prop puller and very easy access to your shaft coupling. There are a ton of sites that describe the process. If you're not starving to death and can afford it, have it done by somebody who knows what their doing. The Idiantown boys aren't bad, but it's not rocket science either. You'll need to get updated on your profanity to do the job right!
09-12-2008 07:22 AM
I would recommend measuring it, since the boat may have been modified from stock.
09-12-2008 01:35 AM
Sometimes the cutless bearing sticks out past the stern tube....if the water is clear you might be able to see if yours does. Then you have to get in the water and measure the OD.....or call someone with a boat like yours and ask them. A user group maybe? It could still be different though....best to measure your own.
09-11-2008 08:40 PM
No strut and thanks for the tip on the diameter.
09-11-2008 05:35 PM
Shaft size will give you ID.... do you have a strut?
09-11-2008 04:22 PM
Need to find the size of cutlass bearing I need as I want to have it on hand when I haul out. Any help?
This thread has more than 10 replies.
Click here to review the whole thread.