|Topic Review (Newest First)|
|05-02-2009 05:55 PM|
Thanks for your help. New HX, hoses and clamps are installed as is a vented loop in the raw water line from the HX to the ehxhaust. We just brought the boat under power 2 1/2 hrs from Forked River to Toms River in NJ and all ran well, no leaks and the motor ran nice and cool. Let the sailing begin!
|04-04-2009 10:07 PM|
|sailingdog||That's kind of why most of us post photos to an external website and link to them using the insert photo icon,|
|04-04-2009 09:13 PM|
This is the best I can do. Cant get it to accept uploads into the post, and when I try to insert image, it gives me a box with red x.
|04-04-2009 06:12 PM|
|jlenox||I was able to upload the photos into the members gallery section. Dont know why I cant get them here. Sorry|
|04-04-2009 05:57 PM|
New part on order
Well, I pulled the HX today and the port side seems to have been braised shut. It is leaking from both ends judging by the green corrosion. I took photos to upload but for some reason was unable to get them to upload "upload failed" even though I resized them to fit the parameters required. Thanks for all the help. I will update once part comes in and I attempt to replace!
|04-03-2009 11:48 PM|
Originally Posted by Pub911 View Post
And people think impeller chunks clog HX's..
|04-03-2009 11:30 PM|
I have had a similar situation occur to me as well. Close-the-barn-door-after-the-horse-got-out advice notwithstanding , I've had good luck just knocking the loose zinc around with a probe. If it fell off the threaded plug, it's like that it's pretty broken down and will crumble without too much trouble. Be careful not to cause any collateral damage as you knock it about. And flush as the unit well so that you get as much of the debris out the zinc-hole as possible.
|04-03-2009 01:49 PM|
Thank you. I hope to pull it this weekend and try to figure out how to open the other end since there is no bolt visible, like on the starboard side. I will post photos. Additionally, I have read many of your posts, thanks for all of the excellent information on a variety of subjects!
|04-03-2009 08:18 AM|
Originally Posted by jlenox View Post
Yes both ends have clean out..
Cleaning a Heat Exchanger
|04-03-2009 05:14 AM|
Universal M-18 Heat exchanger
I was replacing the zinc in my hx today when (as I am reading other posts) I came up with only the brass head because the zinc had broken off, and I could not push the new zinc into the hole as the old one was stuck. I consulted with the yard owner who advised to pull the clean out cover off the end of the hx. My only problem is that there is only one clean out on the hx and it is at the far end of the unit from where the zinc attaches. I noticed significant green crusting on both ends. I am going to pull the hx out this week end to determine if it is salvagable or needs replacing. Does anyone know if the port end of the hx for this motor actually has a clean out or if the end cap is not removable. There is no obvious bolt as there is on the starboard side. Thanks.