|Topic Review (Newest First)|
|06-26-2009 06:25 PM|
Originally Posted by mysticsailor View Post
|06-10-2009 11:14 PM|
Rudder is stainless steel frame welded on a stainless post, then filled in with fiberglass... your water intrusion probably comes from either the entry point of the rudder post at the top of the rudder, or from the top of the tube in the cockpit under the emergency steering plate. These rudder posts were filled with open cell foam allowing water a one way in and no way out unless you turn the thing upside down. I wouldnt be concerned. Mine has water too and its solid as a rock. But If you ARE really concerned, break/ grind it apart and rebuild from the frame up... lots of work= piece of mind. Otherwise put it in a huge contractor bag with a dehumidifier. Works great.
Then seal up the post entry into the glass with marine sealant, and you're done.
|05-11-2009 09:01 PM|
Rudder moisture - S30 MKIII '88
Buying a S30 MKIII 1988.Moisture meter indicated possible water intrusion on the port side of the rudder. Does anyone know the contruction of the rudder on the Sabre 30 and any suggestions on how to address this problem? Surveyor recommended drilling a hole, putting a heat lamp on it and letting it dry out. Any suggestions, advice? Thanks