|Topic Review (Newest First)|
|08-25-2010 11:33 PM|
I would try Discount Marine and Boat Supplies - Inflatable Sales - Defender. They have a good selection of the Marelon type vented loops and the prices are also reasonable. I got mine from them. Depending on where you are located, you could also find it in your local marine store such as West Marine...
Hope that helps.
|08-25-2010 05:30 PM|
Ah, that makes sense, I misread the original post.
|08-24-2010 10:39 PM|
The vented loop is in the raw water injection line before it goes into the exhaust elbow, like the Yanmar diagram below. As it says an anti-siphon or vented loop. Some install a vented loop with a small hose from the top into the cockpit well as it will not clog. And a bit of water spitting out is a comforting thing to see.
|08-24-2010 08:48 AM|
|fawcettm||You know what is nice about venting through the hull, you dont have to lean over so far to check for water coming out of your exhaust, I had a check value on an old vented loop, but it got stuck and took out my regulator below it. Since I put the new line and loop from vetus, I havent had any problems.|
|08-23-2010 03:54 PM|
Are you saying your exhaust is 5/8"? If so that is too small and would cause engine problems like burnt valves.
|08-23-2010 03:43 PM|
As I replace the exhaust system on my ysm8 it previously did not have a vented loop. There is a 5/8" line from the thermostat to the mixing elbow where the vented loop would go. I can't seem to find one for a 5/8" line that I have currently. Any suggestions on where to find? I have seen the Vetus but am not interested in venting that exhaust thru the hull. Can any old vented loop work?