SailNet Community - Reply to Topic
Thread: GROCO-HF Flush-Dry Problem Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the SailNet Community forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
Please note: After entering 3 characters a list of Usernames already in use will appear and the list will disappear once a valid Username is entered.

User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

  Additional Options
Miscellaneous Options

Click here to view the posting rules you are bound to when clicking the
'Submit Reply' button below

  Topic Review (Newest First)
07-03-2006 04:26 PM
SailorMitch Call them. The Groco contact number is at the bottom of the spec sheet. If nothing else, they need to know that their head may have a problem?
07-03-2006 01:27 PM
GROCO-HF Flush-Dry Problem

Iíve rebuilt my GROCO-HF and Iím having problems with the Flush-Dry lever position.

Using the diagram at , the flush lever (part 5) will not move to the flush-dry position. I did this rebuild because the gasket (part 10) wore out. The first time I replaced it, everything worked fine when pumping out the bowl and flushing water through the system. However, when I tried to operate the lever to the flush-dry position, I encountered a lot of resistance. I pushed it on over and managed to rip the gasket (part 10). When I bought another kit and replaced the gasket the lever still would not flip over to the flush-dry position. Given the cost of these kits, Iím not about to force it again!

Has anyone else run into this problem? As best I can tell from GROCOís documentation, everything is installed correctly. With the exception that I still canít see where the ďbridgeĒ (Part 8) goes, so it hasnít been installed. I didnít think that would be an issue given that the documentation says that it was added to later models. Could this be the source of my problem?

If there's a better place or forum to ask this question, please let me know.


Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

For the best viewing experience please update your browser to Google Chrome