Yea to the follow the wires suggestion but lets face it sometimes that can be damn near impossible.
On ours the fluxgate is mounted in a locker in the quarter cabin.
07-18-2011 09:29 PM
I have a beneteau 343 and they mounted it in the aft cabin hanging locker, forward wall. Check the hanging lockers, dealers like to mount things in places where you actually need storage (dont get me started on how the A/C vents were installed in my boat).
07-18-2011 09:26 PM
I bought a Fluke tone tracer for tracing out telephone lines in my house. It would work real well on a boat too, because you don't need to be able to see the wires as long as you get reasonably close, and signal will lead you right to the end of wire.
My house was wired by real fly-by-night. When I remodeled my kitchen I found two flying splices with wirenuts in the wall behind the counter, a plastered over junction box facing into the adjacent room, and another with burned up wiring buried in the ceiling! Hate to think what might be in the rest of the house.
Gary H. Lucas
07-18-2011 09:25 PM
Mine is under the seat for the nav station. What are the symptoms of the problem.
07-18-2011 09:09 PM
Follow the wires
It is connected with wires. If it is hooked up, and on the boat, I guarantee that following the wires will lead you to it!!!
07-18-2011 08:54 PM
checked there, no luck, but thanks
07-18-2011 08:48 PM
Mine is in the bilge just a foot or so from the bilge pump.
07-18-2011 08:21 PM
Auto Pilot Question
i own a beneteau 321 oceanis (1999). i have a raymarine ST4000+ autopilot which is not working properly. from the research i've done i was told that i probably have something metallic too close to the fluxgate compass. my only problem is that i can't find where it's mounted. i've taken apart half of my boat over the past week and i still can't find it. i know what it's supposed to look like but it's nowhere to be found. does anyone have any idea where a few of the places might be where they could hide it.