SailNet Community - Reply to Topic

   Search Sailnet:

 forums  store  


Quick Menu
Forums           
Articles          
Galleries        
Boat Reviews  
Classifieds     
Search SailNet 
Boat Search (new)

Shop the
SailNet Store
Anchor Locker
Boatbuilding & Repair
Charts
Clothing
Electrical
Electronics
Engine
Hatches and Portlights
Interior And Galley
Maintenance
Marine Electronics
Navigation
Other Items
Plumbing and Pumps
Rigging
Safety
Sailing Hardware
Trailer & Watersports
Clearance Items

Advertise Here






Go Back   SailNet Community > On Board > Gear & Maintenance > Rudder Play
 Not a Member? 


Thread: Rudder Play Reply to Thread
Title:
  

By choosing to post the reply below you agree to the rules you agreed to when joining Sailnet.
Click Here to view those rules.

Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the SailNet Community forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
Please note: After entering 3 characters a list of Usernames already in use will appear and the list will disappear once a valid Username is entered.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Click here to view the posting rules you are bound to when clicking the
'Submit Reply' button below


Additional Options
Miscellaneous Options

Click here to view the posting rules you are bound to when clicking the
'Submit Reply' button below


Topic Review (Newest First)
03-01-2002 12:48 PM
Denr
Rudder Play

I replaced the rudderpost bearings a few years ago on my vessel. It is not impossible to do this yourself however one must carefully plan the work and have a helping hand or two when dropping and reinstalling the rudder. When you replace the bushings, do remember to provide for a way to get grease to the bearing to lubricate the bearing/shaft area as this was most likely the cause for premature wear. Before you start, take some rough measurements to make certain that you have enough room under the rudder to drop it completely out of the boat. It is sometime necessary to dig a hole in the ground to provide the clearance required, that is to say a shovel may be one of the tools you''ll need to do the job.
03-01-2002 06:02 AM
Rampager
Rudder Play

Jeff_H - Thanks for the reply. Just to clarify, the play is between the rudder post and its bearing. There is no play between the rudder post and the blade. At what point should the bearings be replaced? The rudder was replaced by the former owner approximately five years ago, presumably, but with no way to confirm, the bearings were replaced at that time.
02-27-2002 02:42 PM
Jeff_H
Rudder Play

There''s not quite enough information here. It sounds like there is either play between the rudder post and its bearings (bushings) or play between the blade and the rudder post. Some play between the rudder post and the bearings or rudder tube is fairly normal. You do need to try to determine the cause because if it is being caused by the post cutting through the glass of the rudder tube then it will weaken the rudder tube over time. More likely than not there are plastic bushings of some kind and they have simply worn or shrunk a little.

If the play is between the rudder post and its fins and the core of the rudder, that is much more serious and should be addressed.

Jeff
02-27-2002 01:56 PM
Rampager
Rudder Play

I have owned a 1985 Cal 35 for the past three years. It has (or always has had) a small(?) amount of play in the rudder - meaning when the boat is on land the rudder can be moved back and forth on its vertical axis, by hand. The rudder does not have rotational play (vis-a-vis no cable tension issues). I have noticed some involuntary rudder movement in a following sea.

Anyone''s thoughts as to the normality of this issue, diagnosis, the probability of future failure, cost to fix, etc. are welcome.

 
Posting Rules
You may post new threads
You may post replies
You may post attachments
You may edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On


All times are GMT -4. The time now is 10:03 AM.

Add to My Yahoo!         
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
(c) Marine.com LLC 2000-2012

The SailNet.com store is owned and operated by a company independent of the SailNet.com forum. You are now leaving the SailNet forum. Click OK to continue or Cancel to return to the SailNet forum.