|Topic Review (Newest First)|
|04-17-2007 05:43 PM|
Our bilge is fairly deep, so we attached the switch to piece of aluminum in the shape of a "L". The top of the "L" is just under the engine and the weight keeps it from floating and allows us to easily remove it from the bilge.
|04-17-2007 05:42 PM|
|sailingdog||One of the better ways to mount a float switch is to mount it to a long, skinny vertical board or piece of PVC pipe. Then you can use screws or other methods to mount the board or pipe in a location that positions the float switch where it needs to be. The bilge pump should be mounted to the same board/pipe. That way, if you need to service it, you can just pull it up and work on it.|
|04-17-2007 05:22 PM|
After you have dried out the bilge. epoxy a mount to the bottom of the bilge for your float switch.
Also if you have found the hole where the water is coming in. Drill a hole next to it for the water to flow out. :rofl
Isn't that what elmer fudd did??
|04-17-2007 05:17 PM|
Quick question - bilge pump float switch
I have installed a new bilge pump, with float switch, in my soggy bilge. The only problem is that the float switch, well, floats. I'm disinclined to poke a hole in my hull by screwing it to the bottom. What's the best way to attach the float switch base?