|Topic Review (Newest First)|
|09-17-2007 12:09 PM|
"Expensive" self-tailing upgrade
Sorry to revive an old thread, but has had any experience with Winchmates? Unlike Winchers, these are true self-tailing add-ons with line guide/stripper.
We have two non self-tailing Barlow winches on the main mast, and while Winchmates are expensive at $US500 list each, it's cheaper than the $750-1200 for new Lewmar/Harken/Andersen ~40-46 self-tailers. Factor in having to re-drill the winchpads, and the Winchmates start to look more reasonable. But then again, the Barlows are old, and there's no telling how long spares will be available from Hutton-Arco in Australia.
|07-20-2007 10:43 AM|
They are available at West Marine and probably other marine stores(SailNet?).
We don't run the sheet in the wincher until we've taken in the slack. I think the term "self tailers" is inappropriate for the Winchers, they are more of a "self gripper". Once you have a couple of turns on the drum and a little tension on the sheet or halyard you just take a turn around the Wincher and it will hold it. As you crank the winch with one hand you just feed the tail out with your other hand, but you don't need to pull any tension on it. When you have it set, we take a couple extra turns on the drum and run it through the Wincher again. Works extremely well for the difference in cost between these and new winches, but they are only a compromise, not an equal to true self tailing winches.
|07-20-2007 09:49 AM|
|1970Columbia34||anyone know the US company that makes them or where we can buy them?|
|07-19-2007 10:45 AM|
|knotaloud||So how do they work? Can you pre wrap the sheet in the Wincher thing before tacking, and still rapidly haul in the sheet by hand before cranking the winch? Or do you haul in the slack first and then wrap the Wincher, prior to winching?|
|07-19-2007 09:56 AM|
|Jotun||I think there is a company in the US that makes them also....|
|07-19-2007 04:34 AM|
|Chelsea||I have used them for the last few years on Barlow 26 winches and have found them to work very well. They do not exactly self tail, you need to strip the tail from the winch, but they sure do help and are better than just a stanard winch|
|07-18-2007 06:56 PM|
|jrd22||We have used them for over 10 years (replaced them a couple of times) and they work great. The only time we cleat them off is if we are in a hard blow, (20+kts) but even then I don't think they would ever let go if you put several wraps on them. They are a poor mans self-tailer, but I'd never go without them again with standard winches. We keep thinking that the original winches (78') will fall apart so we can get new ST's, but they keep going, and going.... My father tried to use them on his 1970 Contest 30, but the top lip of the winch was too thick, most standard winches work though. Good luck.|
|07-18-2007 06:33 PM|
I've used them... they work for the most part... but don't work with as large a range of line sizes as a true self-tailing winch. Also, don't rely on the winchers to hold the line under a load... you still need to cleat the line off properly.
|07-18-2007 06:20 PM|
Non self tailing winches: A cheap fix?
Has anyone had any experience with the Wincher?
I've already replaced my primary winches, but still have standard winches for main and genoa halyards. Just wondering if these things have any real benefit or not? Anyone have personal experience?