|Topic Review (Newest First)|
|07-04-2002 07:25 AM|
I had exact same symptons. My cutlass was totally worn out, shaft was not true, and my prop was out of pitch. I took the whole lot to a prop shop and had prop re-pitched new cutlass pressed in and bought new shaft. Total cost $230.00.-thomas
|07-03-2002 07:10 AM|
When my cutlass bearing wore out it was accompanied by significant vibrations (felt throughout the hull) at higher rpm ranges. In total there was probably 3/32" play between the shaft and bearing.
Fix it quickly! In my case the transmission burnt out while I was trying to hang on until the end of the season.
|07-01-2002 05:58 PM|
Another source can be misalignment of the propshaft as boats change shape over time and vibration dampers sag. It may also be a transmission bearing.
|07-01-2002 05:15 PM|
Another possible problem causing this is a worn shaft. I have had to replace shafts on older yachts. After a number of years SS shafts do wear and over the years can wear enough to need replacement. Measure the shaft when you change the bearing.
|07-01-2002 08:54 AM|
I replaced my cutlass bearing this year. Had similar symptoms. As you boat is in the water I guess I would suggest that you send a diver down and have him tug on the shaft. If there is play between the shaft and the cutlass bearing it probably needs to be replaced.
|07-01-2002 04:00 AM|
What are the symptoms of a failing cutlass bearing? I am gatting a metallic vibration at certain rpm''s , and also when I motor hard to port on my Catalina 30. No vibrations when the transmission is in neutral. Any input?