SailNet Community banner
  • SailNet is a forum community dedicated to Sailing enthusiasts. Come join the discussion about sailing, modifications, classifieds, troubleshooting, repairs, reviews, maintenance, and more!

Help solve a debate..

941 views 2 replies 3 participants last post by  sailaway21 
#1 ·
My buddy says spreaders should extend perpendicularly from the mast.

I think I have read that they should be slightly above the horizontal. And that the angle that is formed from the shroud wire and spreader should be equal above and below the spreader end.

Who's right? Or is no one right?
 
#2 ·
Groundhog-

The spreaders should bisect the angle formed by the shroud at the tip of the spreader. The angle between the shroud and the spreader above the spreader should equal the angle between the shroud and the spreader below the spreader. This will leave them angled upwards slightly.

If the spreader isn't bisecting the angle formed by the shroud, then the shroud can exert a downward torque on the spreader, which it really isn't designed to resist. If the spreader is forced downward, then it will eventually bend and fail... then the mast falls over. This is generally not good and quite expensive. :D See the following thread about this. LINK
 
#3 ·
I would advise you to look at Robert Ganier's post in the thread the Dog linked.

I, of course, spent great amounts of time this spring measuring and adjusting to equalize my spreader angles. I erected my mast, as only I can handle an erection, and the damn things were still basically horizontal-where they've apparently been since about 1973. I have them well seized to the shrouds, so am unconcerned about slippage. Furthermore, for all the Cartesian geometry displayed, I see no allusions to the fact that the spreader does not apply it's strain to the mast proportionately angle-wise. My casual observations show that most seem to be closer to horizontal than bisecting the shroud. Whether correct or not, this seems to be the case. In short, I suspect the actual angle is not critical (how accurate can you get it?) and while upwards to a degree is desirable, slippage is intolerable. JMHO, YMMV
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top