|Topic Review (Newest First)|
|10-03-2007 10:35 PM|
|Freesail99||I did look at cork tiles at one time. They are used in kitchens and baths.|
|10-03-2007 10:32 PM|
|sailingdog||UGH.. Ceramic tile must add an awful lot of weight... how is it fastened to the fiberglass??|
|10-03-2007 09:23 PM|
While we're on the subject...
I have a rather challenging issue with my "ceilings" as well. The PO covered the fiberglass hull with ceramic tile. It's 12"x12" sheets of 1 inch tiles. Needless to say, keeping the grout in good order is challenging. The workmanship in the v-berth and salon is pretty good but the aft cabin is horrendous. We would like to remove it and use some type of wood strips as others have described here. However, the challenge is how to tackle this job. Anyone have any ideas? Has anybody seen this before? It was new to us.
|10-01-2007 04:27 PM|
hmmm interesting. So on a FG boat with no framework per se, such as ribs the ceiling terminology may not apply as it covers the framework not the inner/outer hull surface. They can't be called interior bulkheads because they don't partition anything. I agree that saying 'walls' does seem inappropriate. Maybe inner hull covering or perhaps the 'sides' to go along with the 'overhead' terminology.
|09-30-2007 08:56 PM|
No, No, FullandBy, I think you have it wrong. They were not trying to beat you into the ground.
Rather, what the last few posts seem to be saying is that my earlier usage of "ceilings" is strictly speaking incorrect. The new definitions proferred seem to suggest that it is only the MATERIAL covering this area of the cabin that is known as "ceilings". So in our boat we have teak ceilings, but in your boat you have...not sure what to call it, maybe "carpet ceilings".
But that leaves the question of how to refer to this area of the cabin. All our boats have had "ceilings", so that is the terminolgy we've always used for that area. And it may be that with the advent of fibreglass hulls, that is the convention regardless of whether it is covered with wood trim (maybe that is what Jeff H was suggesting?). In any case, I still don't think we should call them "walls".
This is an interesting distinction that is being drawn, so I've learned something tonight. Thank you to those posters who called it to our attention.
|09-30-2007 08:29 PM|
Ok ok I'm sorry,
I will never say 'interior cabin walls' again. I will write this out one hundred times. Is it possible to change the title of the thread? I feel so ashamed ....
|09-30-2007 06:12 PM|
Originally Posted by gc1111 View Post
|09-30-2007 05:40 PM|
On a boat, ceilings are the planking that you see on the interior of the hull. The underside if of the deck is called the overhead. "Interior cabin walls" is a lubberly way of saying the interior bulkheads and perhaps if lubberly enough might also include the ceilings.
|09-30-2007 04:01 PM|
I am just catching up on this thread. About the confusion over "ceiling", check out http://www.thefreedictionary.com/ceiling
I don't know how authoritative this is, but their Nautical definition is:
"The planking applied to the interior framework of a ship"
|09-30-2007 11:48 AM|
Nice ceiling. I ditto the exclamation on the ports - lovely.
I'm all teak everywhere as well and although it is dark there is enough light in my boat to compensate. I think what you have for planking in your picture is what I will be doing - thinner planks, easier to mold and work with.
|This thread has more than 10 replies. Click here to review the whole thread.|