|Topic Review (Newest First)|
|08-17-2010 10:25 AM|
Raytheon Chartplotter 420 - No FIX
I had this problem and fixed it by replacing the small 'watch' battery (CR2032) in the unit.
Remove the two screws to remove the threaded base. Remove the six small screws and pry the unit apart. The battery is 'stuck' to its electrodes so use a blade and luck to get the old one out without causing damage.Hold the electrode with a needle-nose so that they don't break off.
|01-24-2008 04:54 PM|
|Valiente||Mine was working until haulout just fine. It's currently disconnected from the antenna because the antenna is coming off with the pilothouse roof shortly.|
|01-24-2008 01:08 PM|
Originally Posted by wduncan50 View Post
If all is connected odds are it is because the software needs to be updated...
|01-24-2008 12:37 PM|
Well...that would hav been too easy and simple!
The 420 has a DEDICATED GPS input and cannot post a position from any other NMEA device so you will need to contact Raymarine to find an APPROPRIATE new antenna AND connector...or just get a new plotter with all the good stuff built in.
|01-24-2008 12:01 PM|
|wduncan50||The only connections I see off of the antenna are all in a single cable going to the plotter and the connection there all look good.|
|01-24-2008 11:45 AM|
|camaraderie||Is the ground wire ON the antenna in good shape? This should be checked as well.|
|01-24-2008 11:24 AM|
Raytheon RC420 GPS - no fix
I have a Raytheon RC420 chart plotter that powers up but gets no GPS fix on the sats. I checked the connections on the unit to the GPS antenna and they look good. Do I need a new antenna or is there something else I need to check?