SailNet Community - Reply to Topic
Thread: Mainsail reefing dilemma Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the SailNet Community forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
Please note: After entering 3 characters a list of Usernames already in use will appear and the list will disappear once a valid Username is entered.

User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

  Additional Options
Miscellaneous Options

Click here to view the posting rules you are bound to when clicking the
'Submit Reply' button below

  Topic Review (Newest First)
04-18-2003 03:58 PM
Mainsail reefing dilemma

Jeff, I''m sure that you''re experience is much greater than mine. But in my limited experience sailing a 27'' from San Francisco to Saint Petersburg, delivering a 35'' from Florida to the Netherlands and installing a hundred or so furlers of all sizes and makes, I think you may be a little prejudiced against the whole idea. I am suprised that you haven''t used the old cliche "Roller Fouling". I remember being in 40 to 50 knot winds for 5 days in the Gulf of Papagayo with just a small piece of the genoa out most of the time and I was real glad I didn''t have to crawl around on that pitching foredeck every time the wind let up enough to allow us to carry more sail. And even more glad when I could reef from the cockpit when the wind picked up again.
I know stuff happens, but I repeat, a properly installed and operated roller furling system will make for easier, more pleasant and often safer sailing.
04-18-2003 09:44 AM
Mainsail reefing dilemma

On a 25 ft boat, one reef in the main to reduce it about 30-35%, and a downhaul system for the headsail would provide alot of different sail plans very inexpensively. A line to the head of the jib to a sheave on the pulpit and then aft down the portside to the cockpit. On the foredeck a canvas is tethered to the bottom of the pulpit, with velcro strips on its edges. The headsail is collapsed by releasing the jib halyard, and flaking the jib down onto the canvas by using the downhaul to dowse it and the sheets to keep it taught and aft and on the deck, and folded up and velcro''d. The smaller jib goes up thru the hatch and the larger one pulled down same way. Changing out jibs instead of furling permits you to still go to weather: furling gear, it''s hard to do after about 1/3 is furled in. My C-22 sails well and balanced with one slab reef in the main and a storm jib, in winds over 20 knots (lake sailing, no swells). The main goes from 100 ft2 to 70, the headsail from 100 to 33. Trying this is inexpensive, if you are not happy with it, then at least you know. My downhaul was under thirty dollars, installed: line, sheave, and velcro''d canvas. More sailing, less motoring.
04-18-2003 08:25 AM
Mainsail reefing dilemma

For shorthanded sailing, one of the safest configurations is to go with a main that has slab or "jiffy" reefing, AND either a mast track and slides or luff groove and slugs. That way the sail stays attached at all times. You can shorten sails very quickly, as long as you are familiar with the technique. Bolt-Roped mains & jibs are great for racing and that "Perfect Foil" shape, but are just too scary shorthanded.

For the head sail, good old fashioned hanks on a wire headstay. Again, the sail stays attached and can be dropped quickly. Not as sexy as a roller furler, or as pretty as a twin groove headstay, but who cares about that stuff in a blow on a heaving foredeck!
04-16-2003 06:36 AM
Mainsail reefing dilemma

re: Jeff
04-16-2003 05:01 AM
Mainsail reefing dilemma

Again, while everything can be installed as well as posible and according to the manual, I have experienced so many jambed furlers, especially on boats that were sailed short handed, that I can say with certainty that sooner or later you will get caught in a blow taht sooner or later will jamb your furler to the point that a single-hander will not be able to free it. I love these pie in the sky claims for roller furlers but in reality they are a jamb up waiting to happen.

04-16-2003 04:29 AM
Mainsail reefing dilemma

Goes back to what I said about installation and reading the manual in order to learn how to operate the system. A ratchet block installed as the aft most lead block will usually provide enough tension on the furling line to allow it to wrap around the drum properly. This assumes that the first lead block is positioned 90 degrees to the drum, the line is the proper size, etc. etc.
04-15-2003 06:15 PM
Mainsail reefing dilemma

Actually, in my sailing experience the real most frequent cause of of a jambed furler, is that the jib is rolled out in pretty light to moderate conditions, but as the wind builds so does the force required to furl the jib. this greater force pulls the furling line into the looser wrapped coils and seriously jambs the furler. This is especially prevalent when single-handing because it is hard to keep enough tension on the furling line and sheet at the same time.

04-15-2003 04:14 PM
Mainsail reefing dilemma

Every boat should have a way to reef the main. There are lots of options, but the actual sail modifications should be performed by a qualifed sailmaker.
As regarding roller furling systems for the headsail, almost any system, properly installed will serve well. The problem most people have can be directly traced to improper or incomplete installation. Halyard wrap is by far the most common problem. The second most common problem is that people don''t bother to read the manual.
04-15-2003 02:17 PM
Mainsail reefing dilemma

Now try visualizing if you were alone and a storm come in quickly and the reefing jambs. There is nothing that is quicker, and more reliable than a two line slab reefing system, and frankly it is the only safe way to go when short handing a smallish boat. The problem with roller furling systems besides for their tendancy to jamb under load, is that they result in reefed sails that are the wrong shape for heavy air sailing. Instead of being bladed out as they should be in heravy air, roller furled sails tend to be powered up which means more heeling and helm problems. Even with the new foam luff systems, in a blow of any real length the leech and foot creep toward each other powering up the sail rather than being properly bladed out.

In the worst conditions with furling It is NOT a fast way to take down sail from the cockpit. You can roll the sail up but the increased windage in a real blow is enough to cause a knock down on its own. (been there, done that and already wore out the teeshirt) Dropping the sail means going forward and being down a sail that is only held in a luff groove which is not the easiest thing to do short handed in a breeze that is too big for the sail in question.


04-14-2003 11:47 AM
Mainsail reefing dilemma

I have reef points on my sail put in by the sailmaker. They work well but I really like the roller furling genoa. It is a fast way to take down sail fromm the cockpit and be safely at the helm. I know it''s expensive but it is a really efficient system. Try reefing a friends main sail in mild conditions and then think how it would be if you were alone and a storm come in quickly. My system is designed to allow partial furling with decent sail shape. Nice when those squalls come in so fast, just pull the reefing line and sail is reduced. Takes about 1-2 minutes from the cockpit. Just my thoughts. Tom
This thread has more than 10 replies. Click here to review the whole thread.

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

For the best viewing experience please update your browser to Google Chrome