SailNet Community - Reply to Topic
Thread: Fresh water pressure, help Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the SailNet Community forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
Please note: After entering 3 characters a list of Usernames already in use will appear and the list will disappear once a valid Username is entered.

User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

  Additional Options
Miscellaneous Options

Click here to view the posting rules you are bound to when clicking the
'Submit Reply' button below

  Topic Review (Newest First)
07-28-2003 06:11 AM
Fresh water pressure, help

I''m learning. It was the strainer. I do have a leak somewhere but it is apparently not that bad.

Thanks everyone for the imput.

Nautical Rich
07-26-2003 12:22 PM
Fresh water pressure, help

My experience has been, the emptier the tank, the longer the air pump has to run to build sufficient pressure inside the tank. Do you experience the same performance whether the tank is filled with water or nearly empty?
07-26-2003 01:58 AM
Fresh water pressure, help

OOPS! Did''nt quite pay enough attention to your post.
You say, Pressure builds slowly, when pumping.
Sounds like the impellor or diaphragm needs replacing. Both available as re-build kits.
07-26-2003 01:56 AM
Fresh water pressure, help

Sounds like the fresh-water pump is leaking back, If pressure when pumping seems good (18 - 25 psi), it''s likely the check valve (at the pump).
07-24-2003 06:50 PM
Fresh water pressure, help

Sounds like you are on the right track...must be a leak.

The mystery is why not the hot water side as well? The pump should provide pressure for both sides of the system initally. Maybe a check valve in the hot water side?

You can track down the leak by looking for water dripping/running into the bilge or, open up the system at some point and insert a temporary plug. Turn on the pump and see if it holds pressure. If so, then the leak is likely further down the line. If not, it must be between the temp plug and the pump. Repeat the process until you isolate the problem.

Good luck,

07-24-2003 09:29 AM
Fresh water pressure, help

Here''s the problem: Cold water side loses pressure immediately and it takes quite a while for the pump to build pressure.
The hot water side seems ok even when it has cooled down and sat for a few days.

I am by no means an expert but I think there might be a leak somewhere in the cold water lines. Has anyone any experience in this?

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

For the best viewing experience please update your browser to Google Chrome