|Topic Review (Newest First)|
|07-26-2008 01:28 PM|
|mdharnois||My options were "starting" or "not firing at all," so it wasn't hard to choose. Even tightening the head nuts down a teeny bit tighter requires readjusting the lash.|
|07-26-2008 01:03 PM|
Originally Posted by mdharnois View Post
One note of warning, however: I just spotted the following comments over on the Moyer Marine forums: "Slappy Valves are Happy Valves" and "Better to have valves too loose than too tight was the reasoning. Tight valves might not fully seal and you can burn a valve as the combustion gases escape through its gaps."
I'm no authority on this particular aspect of engines. As luck would have it: All the engines I wrenched-on back in the day had hydraulic lifters .
|07-26-2008 12:20 PM|
This will work. You have to scroll down.
|07-26-2008 11:20 AM|
Not working for me... Just make 10 posts in this thread (anything) and then post the pictures
|07-25-2008 02:06 PM|
I had a Petter (AC1W or AB1W) on my Catalina 27. Spent lots of time messing with it....
I don't recall any funky shifter stuff, but if you posted pictures, that might help...
Have you tried to get a manual from lister-petter?
|07-25-2008 01:18 PM|
I finally got the Petter AB1W on my Coronado 27 running (last owner had left it in little pieces ... final clue to making it start: valve lash is really, really critical) and now I am trying to figure out the drive so I can shift between forward and reverse without having to crawl under the deck or reach over a running engine. There is some sort of mechanism that resembles a pulley mounted at the top end of a vertical lever. Turning the pulley-like disk back and forth moves the driveshaft in and out, one position is forward, the other reverse. There are marks chafed into the disk. In the box of engine parts I found what appears to be a shifter. Disassembling it I found that it appears to take a cable which has grooves on it that fit into notches. The chafe marks on the disk appear to match those inside the shifter. However, I haven't yet found a corresponding cable on board, nor can I figure out where the shifter has ever been mounted. It has two fittings on the bottom that it appears would go through the cockpit sole. The ends of the fittings are tapered and threaded to accept compression fittings, and also in the box of parts were two 2' lengths of small copper tubing with compression fittings that match. Can someone give me a clue how all this is supposed to work?