SailNet Community - Reply to Topic
Thread: Rebuilding seacocks Reply to Thread
Title:
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:
 

Register Now



In order to be able to post messages on the SailNet Community forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
Please note: After entering 3 characters a list of Usernames already in use will appear and the list will disappear once a valid Username is entered.


User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in









Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



  Additional Options
Miscellaneous Options

  Topic Review (Newest First)
01-04-2004 01:32 PM
Jeff_H
Rebuilding seacocks

Genuine tapered plug seacocks are quite easy to rebuild. You disassemble them and clean the tapered plug and the valve body with mineral spirits. Then coat the inside of valve body with using the finest lapping compound (bought at a automotive parts store for hand grinding engine valves.) Then insert the tapered plug and move back and forth over something like 180 degrees while keeping even pressure on the tapered plug in the valve body. Disassemble and carefully remove all of the lapping compound. Then coat with waterproof axle or water pump grease as you reassemble the seacock. It should work fine.

Ball valves and gate valves have ''seats and seals''. Tappered plug type seacocks do not. If they have a seal they either have rubber washers or O-rings at the ends of the shaft. They usually don''t even have those.

Jeff
01-04-2004 12:59 PM
aphil138
Rebuilding seacocks

Has anyone had any luck rebuilding seacocks. I have a couple of 1981 vintage 1 1/2 inch Perko seacocks that are pretty cruddy. I noticed that Perko offers rebuild kits..... new seats, seals and o-rings for about 1/3 of the cost of replacement. It doesn''t look like these valves have had any attention in quite a few years.
Alan

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

 
For the best viewing experience please update your browser to Google Chrome