SailNet Community - Reply to Topic

   Search Sailnet:

 forums  store  


Quick Menu
Forums           
Articles          
Galleries        
Boat Reviews  
Classifieds     
Search SailNet 
Boat Search (new)

Shop the
SailNet Store
Anchor Locker
Boatbuilding & Repair
Charts
Clothing
Electrical
Electronics
Engine
Hatches and Portlights
Interior And Galley
Maintenance
Marine Electronics
Navigation
Other Items
Plumbing and Pumps
Rigging
Safety
Sailing Hardware
Trailer & Watersports
Clearance Items

Advertise Here






Go Back   SailNet Community > On Board > Gear & Maintenance > Teak Decks & Grinding the caulking down
 Not a Member? 


Thread: Teak Decks & Grinding the caulking down Reply to Thread
Title:
  

By choosing to post the reply below you agree to the rules you agreed to when joining Sailnet.
Click Here to view those rules.

Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the SailNet Community forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
Please note: After entering 3 characters a list of Usernames already in use will appear and the list will disappear once a valid Username is entered.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Click here to view the posting rules you are bound to when clicking the
'Submit Reply' button below


Additional Options
Miscellaneous Options

Click here to view the posting rules you are bound to when clicking the
'Submit Reply' button below


Topic Review (Newest First)
10-29-2008 09:33 PM
KeelHaulin You might try a razor blade scraper; it would be a long, difficult task but it could be done.

Caulked teak decks usually have a piece of cotton string beneath the caulk (if done properly) so you can pull the string and lift the caulking out. This is done so that re-caulking is easily done to protect the underlying deck from leaks. At 20 years old without re-caulking it probably is either time to re-caulk or replace the teak decking depending on how much deck material is left.
10-29-2008 09:17 PM
sailingdog I would second using a sharp chisel... since the sander is probably going to damage the teak.
10-29-2008 08:50 PM
Quickstep192 This isn't exactly the same thing, but I think the principle still applies.

Years ago I re-caulked the hull of a wooden boat and worked hard to get the polysuphide that I topped the joints with dead flush. When the planks expanded, the caulk sat higher than the planks, just as you describe with your deck. I shaved off that high spot using a very sharp chisel; just carefully pushed it along trimming the caulk flush with the planks. Sometimes it would dig in when I wasn't careful enough, but those instances were easily sanded out.

HOWEVER...... If I'm not mistaken, the caulk joint on decking doesn't go the full thickness of the plank. If the deck is worn down and you remove the caulk, you might expose the joint.
10-29-2008 11:12 AM
xcbxer My teak deck is less than 5 years old and the caulking is already a bit higher. I was told a belt sander works, if and when you want to get at the teak.
10-29-2008 11:04 AM
dsbentley
Teak Decks & Grinding the caulking down

I have teak decks with were done 20 years ago with the black caulking. Now that the teak has weathered the black caulking if about 1/16 to 1/8 inch higher than the decks. I was told I could use an 8" grinder with a soft pad and 80 and 120 grit sandpaper to cut this down. I would think this would scratch the teak and leave swirl marks, but the guy who told me said it wont. Any thoughts on that?

 
Posting Rules
You may post new threads
You may post replies
You may post attachments
You may edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On


All times are GMT -4. The time now is 02:11 PM.

Add to My Yahoo!         
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
(c) Marine.com LLC 2000-2012

The SailNet.com store is owned and operated by a company independent of the SailNet.com forum. You are now leaving the SailNet forum. Click OK to continue or Cancel to return to the SailNet forum.