|Topic Review (Newest First)|
|04-26-2012 11:16 PM|
Re: Repowering a CS 36T
Well, the only reason I'm looking at the W-46 is because there's a really nice rebuilt one for sale cheap that's available (~$1500). I've also been told that the original w-30 is a bit underpowered for the boat (at least for rough weather), so wanted to upgrade the horsepower a bit (although the 46 is almost certainly more than would be needed). Basically, I'm just looking to see if the w-46 would work, as the opportunity to get one cheap seems to exist...
|04-26-2012 09:20 PM|
Re: The 44B
Originally Posted by jmcelwee View Post
You also might consider a Beta. If I were re-powering today it would be one of the top contenders. Stanley at Beta is about as good as it gets with customer support and working out the "fit"..
|04-26-2012 08:53 PM|
Re: The 44B
Hi Maine Sail,
I'm looking at repowering a CS36 with a westerbeke w46. It's slightly longer than the 44B (~1.5 inches longer), but otherwise very similar overall. Do you think this would work in the CS36? Could you let me know what kinds of modifications were required? Thanks!
|03-18-2009 02:35 PM|
The 44B fits perfectly with the Hurth MIV-150 V-Drive. The only modifications were quite minor.
Stbd rear mount:
You will need a new shaft and likely a prop.
|03-18-2009 01:34 PM|
I don't have any advice to give but I'm looking into buying a CS36T and, if you don't mind, I would be very keenly interested in how much this repowering winds up costing you, what's involved, etc. Some of the engines I've been seeing seemed dodgy, I'm almost taking for granted that I'll be repowering too.
In fact, given how cramped the engine compartment is it baffles me how this engine can even be removed.
|01-19-2009 05:13 PM|
Repowering a CS 36T
The notarious westerbeke 33 in my CS 36 finally lived up to its reputation; cracked piston. On pulling the head found the cylinder walls were pitted, looks like water intrusion somewhere in the boats past. Mechanic says tolerance in walls too tiny to permit rebuild (rebore) so a new engine is in the works.
Looking at a Westerbeke 44. It will fit the Hurth trans via an adapter plate. Has anyone done this already? Would you still go with the 44 or would you go Yanmar or some other engine?
Any suggestions or advice would be appreciated. I am not mechanically inclinded but I want to know what is going on.