|Topic Review (Newest First)|
|04-22-2009 08:08 AM|
The headsail sheets should make at least two wraps around the headsail when it is properly furled. This will greatly reduce the chances of it flogging, but the sheets also have to be cleated off properly—and using a self-tailing winch is not cleating them off properly, since the wind could possibly blow the line out of the self-tailer.
Originally Posted by montenido View Post
|04-22-2009 01:39 AM|
Hi all, thanks for the additional information. To answer one question, I don't think that I had secured my headsail sheets back to the cabin. So the furling line was secured, but not the sheets. This must have allowed the sail to unwind a bit and flog itself to death. SD, good suggestion about the sail tie. I did actually have a bungee around the furled sail, but it was not up to the task. I will continue to wrap the sail tightly and secure the lines to the cockpit. That is more than I was doing before
I get my sail back this week sometime, I can't wait. There is quite a difference between the 110% that I am using now and the 150% that is being repaired. On the plus side, I have sailed four times in 1 1/2 weeks.
Thanks again for the great info.
|04-16-2009 08:16 PM|
In high winds, the loads imparted to the sheets can be enough to cause a drum to unfurl if the furling line lets go or chafes through. Particularly so if they flog about. Most drums have one or more holes at the base that allow one to drop a locking pin or bolt through (tie a strip of red spinnaker cloth to the top of the bolt to remind oneself it is in place). Short of that, pulling the sheets forward and tiying them to the bottom of the sail with a couple of wraps of a sail tie will keep things tidy.
PS: We have used Sailcare but for simply sewing up a couple of seams and repairing a UV cover, the local North loft is sufficient and a heck of a lot faster!
|04-16-2009 08:10 PM|
Paranoia is never a bad thing when dealing with New Englad weather...
Originally Posted by nk235 View Post
|04-16-2009 07:46 PM|
Originally Posted by sailingdog View Post
|04-16-2009 07:07 PM|
I do the same thing... but you have to remember to put a few extra turns on the furling drum so you can do this. Also, I highly recommend leaving a few wraps on the drum, since some of the drums can split if the loads get too high on it and there aren't at least a couple warps of the furling line on it.
The reason I put the sail ties on the sail is if the furling line breaks or comes loose... it prevents the sail from unfurling. It's a bit overkill for normal weather, but if I'm going to be leaving the boat for more than a few days or if heavy weather is expected, I'll do it. The sail tie will also go around the genoa sheets that are wrapped around the sail, so they can't come undone.
Originally Posted by nk235 View Post
|04-16-2009 06:42 PM|
This may be a stupid question and in no way am I directing it at the OP as I feel your pain on the sail work (going through the same thing with my furler and rigging now myself)
But how exactly does the sail unfurl itself in high winds? When I roll up my sail I make sure to roll it up so that it has about 3-4 wraps around it with the sheets acting like a sail tie I guess. Also before I coil up the sheets in the cockpit I make sure they are sheeted off fairly tight to a cleat so there is no way they are going to ease up. Also I make sure the furling line is well secured to its own cleat the everything is rolled up tight and cleated off so it can't unwind.
I am just curious if this is what everyone else does/what you are suppossed to do and how the sail could come loose from that?
|04-16-2009 05:59 PM|
I highly recommend putting a sailtie around your roller furled headsail if you're going to be away from the boat for any significant period of time...or get a headsail sock. Either of these will prevent the sail from unfurling and flogging itself to pieces. The sock has the added advantage of protecting the sail from UV damage.
|04-16-2009 03:11 PM|
I've sent twice (different sails) to SailCare. The first time I had no other option since I'm in Mexico and there aren't reputable lofts around here, the sail came like new and I mean like new, really.
the second time I sent my main to have the batten pockets redone and the result was the same.
Not cheap thouhg, I will send again any sail that needs repairs/cleaning.
|04-16-2009 02:48 PM|
Second vote for Sail Care, They took a 22 year old sail and made it look brand new. $48/hr for repair work, should be well worth the cost of shipping to you.
|This thread has more than 10 replies. Click here to review the whole thread.|