|Topic Review (Newest First)|
|04-26-2009 01:03 PM|
re:blanking gate valves
Thanks very much for the advice. I have know idea what the gate valves were for. My boat has 6 completely unnecessary thru hulls and I intend to eliminate every last one of them! Most have been heavily glassed from the inside only and I'm pondering the best way of finishing them from the outside
|04-26-2009 09:02 AM|
Just curious, what did the gate valves supply water to???
Yes, removing the valves and putting a female blanking plug or pipe cap over the through-hull is a solution, but you may have a problem with thread type, since through-hulls are NPS thread and the pipe cap may be NPT thread. However, it will probably work in that case, but it won't be ideal.
|04-26-2009 03:58 AM|
blanking gate valves
I am in the process of restoration. My boat is on a "semi dry dock", that is on a very high tide it floats in about 1 foot of river water. I noticed that has two old gate valves which are leaking. Eventually I think will glass over but in the meantime is it enough to remove them from the thru hull then to screw a female blanking plug onto the thru hull and use thread sealant? Would i have any problems matching threads?