|Topic Review (Newest First)|
|06-06-2009 10:12 PM|
Originally Posted by Walt440 View Post
|06-06-2009 05:20 PM|
I'm rather a novice. By split mainsheet do you mean a line from
the boom to Port through a block, and a line to starboard through
a block where you pull on one and release the other to control
the angle of the boom?
|05-26-2009 11:59 AM|
Do check that the boom and goose neck can handle a vang.
Originally Posted by Faster View Post
In some cases, if it was designed for, the goose neck or boom can break.
|05-05-2009 04:18 PM|
the traveler system is simpler. Nothing wrong with a split mainsheet, it's just more complicated.
Me, when close-hauled, I'd rather have just one system for the Up-down component (mainsheet) and just one for in-out component (the traveller).
Just my own opinion.
|05-04-2009 09:02 AM|
I thought of another point.
With travelers you can have settings and pre-assigned "gears", numbered even.
Can't see how you can do that with split mainsheets.
|05-04-2009 02:23 AM|
[quote=Faster;482463] On the plus side, less cost, the cockpit is clear of traveler obstruction and at anchor you can secure the boom very well with the two sheets pulling against the topping lift/halyard . . . [quote]
Another one on the plus side is that the absence of a traveller (depending on its location of course) will not result in anybody's fingers lying twitching on the deck.
|05-03-2009 11:34 PM|
I think you can get just as good control with a split mainsheet setup as a traveler... but much less conveniently. It's usually easier to adjust a good traveler setup than to "tweak" the sheet, esp at the higher wind ranges, so having to adjust two mainsheets (often far apart) won't be as smooth or as accessible.
Also, more line on the cockpit floor..... On the plus side, less cost, the cockpit is clear of traveler obstruction and at anchor you can secure the boom very well with the two sheets pulling against the topping lift/halyard - much less tendency for the boom to swing in some waves and a more secure grab point too.
btw - re the Vang... a missing vang is not deal breaker, but should be way up on your list of things to do as soon as possible....
|05-03-2009 10:19 PM|
|zAr||That does make sense. Easier is good. I guess the important thing would be the ability to quickly release the mainsheet. And the preventer would be good for keeping the sail steady downwind while crossing wakes.|
|05-02-2009 08:24 PM|
|jrd22||My son's Bayfield 36 has a split mainsheet. I was on the boat for several days and I liked it, it was easy to adjust and it also acts as kind of a preventer. I don't know that you get as much precise control as with a single sheet and traveller, but unless you are racing I think it works very well.|
|05-02-2009 06:58 PM|
Pros and cons of split mainsheet system
Can someone weigh the pros and cons of a boat rigged with a split mainsheet system as opposed to mainsheet traveler?
I'm going to look at such a boat soon.
From the photos I'm having trouble spotting a boom vang too...