SailNet Community - Reply to Topic
Thread: Temp Sending Unit on Heat Riser - how to test? Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the SailNet Community forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
Please note: After entering 3 characters a list of Usernames already in use will appear and the list will disappear once a valid Username is entered.

User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

  Additional Options
Miscellaneous Options

Click here to view the posting rules you are bound to when clicking the
'Submit Reply' button below

  Topic Review (Newest First)
05-22-2009 07:59 PM
preservedkillick Thanks guys, it's a single wire. I'll test by grounding.
05-22-2009 01:06 AM
lshick There are two types of senders: those that drive a gauge, and those that drive an alarm. tommays is correct about the behavior of a sender that drives a gauge. In many cases, a sender that drives an alarm is mounted on the ground side of the alarm circuit; in case of an overheating situation, the switch inside the sender closes to complete the circuit to ground.

I have tested the alarm on my boat by touching the wire to ground, as you suggested.
05-21-2009 08:08 PM
tommays There is generally a sender that that changes Resistance to control the gauge and if you touch the CORRECT wire to the block the gauge should move

And a separate unit with a switch that would run the alarm at the temp that is to hot
05-21-2009 07:50 PM
Temp Sending Unit on Heat Riser - how to test?

I've got a temperature sending plug on the heat rider coming off the back of my Vetus engine with no wire connected to it. I'm trying to figure out which wire connects to the spade connector on the sending unit, not (yet) if the sending unit works. The wire according to the wiring schematics that should connect, is not, but is connected to a plug on the engine pan (the very bottom)?

What I'd like to do is see if I can trigger the high temp alarm using that wire, but I'm not quite understanding how the sending unit works. With just a single wire, I'm assuming the sending unit closes a circuit by grounding the wire lead to the engine block?? If I take the wire and touch it to ground, shouldn't the alarm activate??

Am I close?


Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

For the best viewing experience please update your browser to Google Chrome