SailNet Community - Reply to Topic

   Search Sailnet:

 forums  store  


Quick Menu
Forums           
Articles          
Galleries        
Boat Reviews  
Classifieds     
Search SailNet 
Boat Search (new)

Shop the
SailNet Store
Anchor Locker
Boatbuilding & Repair
Charts
Clothing
Electrical
Electronics
Engine
Hatches and Portlights
Interior And Galley
Maintenance
Marine Electronics
Navigation
Other Items
Plumbing and Pumps
Rigging
Safety
Sailing Hardware
Trailer & Watersports
Clearance Items

Advertise Here






Go Back   SailNet Community > On Board > Gear & Maintenance > Galley Water Pump
 Not a Member? 


Thread: Galley Water Pump Reply to Thread
Title:
  

By choosing to post the reply below you agree to the rules you agreed to when joining Sailnet.
Click Here to view those rules.

Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the SailNet Community forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
Please note: After entering 3 characters a list of Usernames already in use will appear and the list will disappear once a valid Username is entered.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Click here to view the posting rules you are bound to when clicking the
'Submit Reply' button below


Additional Options
Miscellaneous Options

Click here to view the posting rules you are bound to when clicking the
'Submit Reply' button below


Topic Review (Newest First)
02-25-2006 09:33 AM
atemplet If the above doesn't work, try the valve cartridge. Remove the handle, then usually a crescent wrench to back off and make sure there is no trash in the valve seat area.

good luck,
ap
06-23-2001 07:45 AM
yandina
Galley Water Pump

Remove the screw on strainer that is on the spout of the faucet. Be careful not to lose any of the little diffusers inside and take it apart and wash out dirt that has been trapped there, then re-assemble.
06-21-2001 02:41 PM
maureena5
Galley Water Pump

Chris & Tom S.,
Thanks for your advice! I really appreciate the insight. The faucet in the head works great. I''ll check out your suggestions. This is our second season with the boat and we are learning, learning & learning more. We''re enjoying great sails too! This board is great. Thanks again.
06-21-2001 10:29 AM
Headman
Galley Water Pump

Maureena5
You didn''t say if the pressure was weak at every faucet on the boat or not. If it is one faucet, look for a kinked line or something crushing the line or a trapped air bubble at the top of a loop. Is it hot and cold side? Accumalator tank could be problem, but I would think that would cause the pump to cycle often and the pressure to fluxuate accordingly. If the pump isn''t running and you have low pressure at the outlet, I would bet on a kink. One other test you can do is to turn the faucet off and wait for the pump to quit running then turn it back on. If you get a burst of pressure and then weak flow, look for the blockage in the line. I have had to take a spare valve assembly and break into the water system up-stream of the faucet and try it there. Then it is just a matter of isolating the section of piping/hose to see where you are loosing in. Try as close to the pump as possible first to eliminate the pump as the problem. Good luck.
Tom S.
06-21-2001 09:58 AM
cditzen
Galley Water Pump

Hi there,

a couple of things come to mind. You could have air in the system, or your accumulator tank is going out. I typically get air in the system if I run it completely dry (e.g. forget to refill the tanks in time). If that''s the case, the easiest thing to do is to run the system continuously for a while to help the bubbles get out (works for me). However, if you have some real loops in your water hoses, air might just get stuck there, and you''ll have to resort to nastier methods.

The accumulator tank actually provides/maintains pressure in the system. Basically, the water pump turns on and builds a certain amount of pressure, and then shuts off. If you now turn the fosset on, the accumulator tank provides the initial pressurized water. If it''s busted, your initial pressure will be low, and the pump may cycle excessively on/off.
Hm, one other possibility is that you just set the pressure to low on the ShurFlow pump. If I remember correctly, most of them have an adjustor close to the inlet/outlet. However, this will only make a difference if the accumulator tank is working.

...Chris
06-21-2001 07:23 AM
maureena5
Galley Water Pump

Hi All,
We recently installed a Shurflo water pump in the galley sink of our l982, 34ft C&C. We did this because the water pressure was so weak. The new pump has made no difference. We cleaned the faucet of all gunk and still no difference. Any thoughts or suggestions on this matter? Thank You!

 
Posting Rules
You may post new threads
You may post replies
You may post attachments
You may edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On


All times are GMT -4. The time now is 10:03 AM.

Add to My Yahoo!         
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
(c) Marine.com LLC 2000-2012

The SailNet.com store is owned and operated by a company independent of the SailNet.com forum. You are now leaving the SailNet forum. Click OK to continue or Cancel to return to the SailNet forum.