|Topic Review (Newest First)|
|07-06-2009 04:22 AM|
I had the same problem twice with my Auto 500 GPH Bilge Pump
When the Auto Switch stops working, I just pull it apart and clean up the contacts. Usually lasts another 6 months before I need to clean it up again
|07-04-2009 09:46 AM|
|RogerDuncan||I agree - clean it out . bilges can get cruddy|
|07-02-2009 09:02 PM|
|scottyt||i had several float switches fail, either wont shut off or wont run. i went the ultima electronic switch and its been fine. i just check it monthly and wipe it off, as most time i read about it not working was due to it being dirty|
|07-02-2009 06:46 PM|
|bubb2||It's gunked up. Pull it apart and clean it.|
|07-02-2009 06:32 PM|
Sticky float or sticky contacts.
|07-02-2009 05:43 PM|
Automatic Bilge Pump Won't Shut Off
Last year I installed a small bilge pump with a built-in float switch. I also installed an auto/manual/off switch and generally left the pump in auto mode.
After a long spring that involved a rudder rebuild and assorted related problems, I launched last week. I've discovered that the bilge pump no longer reliably shuts itself off. If left on auto, it will run until it's quite hot.
The pump is a Seasense Auto 800 GPH model (manufacturers' info here).
Any suggestions on how I might diagnose the problem?