|Topic Review (Newest First)|
|10-22-2009 11:14 PM|
|10-22-2009 08:31 PM|
Gary H. Lucas
|10-22-2009 08:00 PM|
|scottyt||jordan and gary, i am amaster electrician, i already have the benders. i have tried it the problem is its its racked. and out of square. it needs a jack to un rack it|
|10-22-2009 06:30 PM|
Gary H. Lucas
|10-22-2009 03:32 PM|
Have you tried the conduit bender yet? I've got one for sale, cheap. I tried to bend it with out tying it down and got nowhere. After I secured the area next to where I wanted the bend to occur, so it would not move, I was able to apply bends pretty precisely to the location I wanted to. My first bend was too much and I had to remove some of it. I then put a few bends on each side I wanted to bow out so it came out as a smooth curve along the section instead of a single bend.
Granted mine is pretty basic and the amount of movement I had to make was simple, but you might get something more square then let the bolts do the rest.
|10-22-2009 10:31 AM|
|scottyt||i wish my pulpit was that easy to bend. mine has a top and a lower pipe plus 4 verticals ones and its racked out of square. i have tried to get mine to straighten to where i need it and it wont move. i have to make a new one in the spring, or use hydrolics to try to bend it|
|10-22-2009 08:38 AM|
Looks good to me. Great job!!
|10-21-2009 01:59 PM|
|10-21-2009 01:54 PM|
|10-21-2009 01:11 PM|
This is how I did it
Just following up on my thread, so it may be used as an archive in a search.
I was able to find a conduit bender from Lowes for $38. First attempt was with me holding the pulpit while my wife cranked on the bender. It felt like it moved but no such luck.
The hard part is I needed to isolate the area next to where I wanted to make the bend from moving. The plan was to lash it to an immovable object the crank. Here is the setup. I made bend in two places along the area and then put it against the boat and it was a bit too wide. So I removed some of the bend and flipped the pulpit around and bent the other side. Here is a photo of the setup and the results.
PS the 3/4" conduit bender worked on 7/8" tubing pulpit and I guess it would work with 1" as well
|This thread has more than 10 replies. Click here to review the whole thread.|