|Topic Review (Newest First)|
|06-07-2010 07:39 PM|
|mitiempo||Wondered what happened to you Gil. Glad it worked out.|
|06-07-2010 07:05 PM|
|Skipper Joe||Welp, I finally ordered the stuff and hung the tank off the stern rail using the old horseshoe lifesaver holder. On Gary's advice everything was a standard fit. Cooool! Actually, HOT.|
|01-20-2010 05:17 PM|
|Skipper Joe||Thanks Gary!|
|01-17-2010 08:10 PM|
Originally Posted by GilStump View Post
Hope this helps,
Gary H. Lucas
|01-15-2010 06:40 PM|
Originally Posted by SimonV View Post
|01-15-2010 05:22 PM|
|Skipper Joe||Saving up the $300! Maybe I'll become a raw foodist and throw the whole system overboard. I could put an easy chair where the stove is.|
|01-14-2010 04:10 PM|
|mitiempo||Gil, are you cooking yet?|
|01-13-2010 03:06 PM|
No problem as long as the joints are gas tight. Just make sure the threads match.
|01-13-2010 02:48 PM|
So, a 3/8" to a 9/16" increase in size won't mess too much with pressure issues?
Thanks for taking all this time.
|01-13-2010 12:53 PM|
Good morning Gil
What I would do is take the elbow off and take it to a supplier and buy an elbow that matches on one end and gives you the 3/8 male flare on the other. It's neater that way. Take your new supply hose with you so it can be matched and tell them it is for propane. If you have to you could leave the elbow and buy a pipe thread to 3/8 male flare to fit the existing elbow. You should take the old hose end with you if you do this to get an accurate match for the thread of the existing elbow.
|This thread has more than 10 replies. Click here to review the whole thread.|