|Topic Review (Newest First)|
|05-08-2010 03:49 PM|
A little dish detergent in the water reduces surface tension and acts as a lubricant for a few seconds more "working time" and the squeegee slides a little smoother. However, having never done it without the soap I guess I can't say for sure.
That's how someone taught me to do it ages ago and since it worked I never thought to question it.
BTW your stripe looks excellent.
|05-06-2010 10:50 PM|
Originally Posted by capttb View Post
What is the soapy water for?
|04-15-2010 11:18 AM|
Originally Posted by gershel View Post
As for my technique, it is hard to describe, but I basically stick down one end, wherever you want to start. I then keep the tape taught, being careful not to over stretch, and pull the backing paper for a good length (for me, probably six to seven feet at a time). Then, keeping the tape away from the hull (you don't want it to stick until you are ready), sight down the length of the material until it follows the lines you want. Then, slowly bring it to the hull for initial contact. To follow the hull lines, you will need to raise/lower the tape as it is coming in contact with the hull. The longer the lead section you work with, the straighter your lines, and it will better allow for graceful curves along the hull. I keep pulling the backing tape as I move along, so that there is always several feet of tape ready to stick. When you get to the end, stick it down longer than the point you want to stop, then trim with a fresh razorblade.
I hope this makes sense (much easier to show in person than to write-up.).
|04-14-2010 09:16 PM|
|southshoreS24||looks pro to me!|
|04-14-2010 08:11 PM|
|MarkCK||Here is the finished project. I found 80 foot of tape at a local autographics place. It didnt turn out too bad, not exactly professional looking, but not too bad. I had my first sail of the season today.|
|03-14-2010 01:01 PM|
|Matto||It hasn't come in yet so I haven't paid for it but I seem to recall the shop saying it would be around 60 bucks. That's for a 150ft roll of 1in wide tape.|
|03-13-2010 09:58 PM|
|bljones||take your time, and on relatively straight sections work on spaces as wide as your arm span. lay the tape out, gently press it down, step back to make sure it is straight before you burnish it. if you have a cruve to work with, lay down a guide edge using masking tape first. cut the masking tape as need to provide a guide line that follws the curve you want, then lay out your tape with an edge of the tape butting up against your masking tape guide. if you have to cut your stripe tape to allow the necessary relief to follow the curve, use a SHARP razor blade or olfa cutter, then overlap pieces and trim back the overlap. This is the really big advantage of tape over paint. If you screw up you can simply pull it off and start again.|
|03-13-2010 09:45 PM|
What's the trick for geting a a smooth curve? I replaced my 2" stripe a few years ago, and as careful as I tried to be, I still got some slight waves.
|03-13-2010 07:54 PM|
|MarkCK||The 3m scotchal is on my short list of what I am going to buy. Can I ask what the auto shop charged for the roll?|
|03-13-2010 02:41 PM|
|Matto||I've ordered myself a 150' roll of 3M scotchcal striping tape from a local automotive detailing shop. According to 3M it's good for boats, anyone here have experience otherwise?|
|This thread has more than 10 replies. Click here to review the whole thread.|