|Topic Review (Newest First)|
|07-14-2010 06:54 AM|
|Bobio||I used several materials and methods, the safety strip was effective in softening the lettering enamel and not damaging the Awlgrip clear coats, I found that a citrus stripping compound was much more aggressive and damaging to Awlgrip. We had at least two coats of thick lettering enamel to remove. My recommendation would be to be extremely careful with any stripping materials and use it only to slightly soften the lettering paint. In the end I found the most effective method to be use of a foam wheel on a drill in combination with water and a 3M rubbing compound intended for use on painted surfaces. This was effective after I softened and scraped most of the lettering paint using plastic razor blades. It took a long time. Good luck.|
|07-12-2010 01:13 PM|
|sawingknots||i would try lacquer thinner,just apply sparingly and rub off the unwanted paint and wash immediately with soap and water afterward,it will dissolve the newer paint first|
|07-12-2010 12:01 PM|
We are in a similar position: painted name on painted hull. Haven't tried anything yet but about to. Any updates, Bobio, on how you fared with the Dumond Smart Strip?
|03-13-2010 11:52 AM|
Originally Posted by Bobio View Post
|03-13-2010 11:46 AM|
Removing lettering over paint is tricky. My standard tool is a razor blade and extreme care and patience. First you absolutely must dull the ends of the razor blade. I use a sharpening stone to round the ends off including rounding on the angle of the blade itself (hope that makes sense). If you do not do this you will scratch the surface. If your lettering is vinyl you can lift an edge with the blade and slowly peel it off. You can warm it a bit with a hair dryer or heat gun but sometimes this makes things worse as the vinyl will come off and leave the glue and might soften the paint underneath.
If the lettering is paint I would first try the razor blade, if no success I would sand with 400 wet, or even finer and finish off with 1000.
There is a good product for removing glue. Goo remover maybe, can't remember. I have a bottle on the boat.
Good luck, take your time, test a small area first, and be very very careful.
|03-13-2010 10:08 AM|
Lettering paint removal
Iím trying to remove painted lettering on a hull that was painted with Awlgrip about 15 years ago (navy blue with several clear coats). Has anyone found a stripper that is fairly aggressive but doesnít harm the Awlgrip? Lettering was applied by a sign company, I think there are 2 coats. Citrus stripper, acetone and paint thinner donít work. Oven cleaner seems to soften the lettering paint just a little. Awlgrip tech help didnít have any specific recommendations. Planning to try Dumond Smart Strip next.