|Topic Review (Newest First)|
|04-20-2010 12:07 PM|
|CalypsoP35||Remetau, that's very close to where I would have ended up if I was not able to get them into my combing boxes. I don't have a turtle like that, but I would have mounted them on brackets under the dodger on both sides of the companion way. My only hesitation was that I do a little racing and will sometimes take the dodger down, thereby leaving them very exposed to spray.|
|04-20-2010 11:56 AM|
|remetau||I know that this is a little late, but here is what we did since we did not want to put any large holes in our cockpit. We got some side mount Bose environmental speakers and mounted them to the sides of our turtle which is under the dodger. The speakers are on the sides and out of the way and point towards that cockpit. I bought a speaker a/b switch that I have by the stereo in the salon. The back outputs from the stereo go to the a/b switch that has an output for the back speakers in the salon or I can switch to the output to the cockpit speakers or both.|
|04-20-2010 11:39 AM|
Finally did it!
Well, I finally got around to my speaker project. I ended up buying PolyPlanar 4" subcompact speakers. I was hoping I could get the 4" speakers into my combing boxes which have a 3.5" opening by angling them a little. Unfortunately they would not fit. So what I ended up doing is taking them apart and putting slits into the speaker box which allowed me to squeeze the speaker box into the combing boxes. (Once the speaker was taken apart the speaker itself could be slid into the opening. I then filled the slits with 5200 sealant and put the speakers back together inside the combing boxes where they sit on the brackets that came with the speakers. I was also able to angle them forward a little without them being to deep into the combing boxes.
Sound is pretty good, I was not expecting concert hall sound from a pair of $60 speakers. The reason I used them was because they were the smallest ones I could find.
I had found a pair of surround sound speakers that were smaller but I was told they do not have the sound range that regular speakers.(thanks Cam!) I also found a couple of small winch covers that I will use to keep them even more protected from the elements.
Thanks for everyone's input and comments!
|03-18-2010 08:59 AM|
|SVCarolena||We installed a sound system last summer and also when through this thought process. I wasn't willing to cut large holes in the cockpit, so we were left with two options. First, however, we decided on two speakers wired to the rear channel of the head unit - that would leave the front channel for two speakers in the cabin. The first mounting location we considered was similar to what SD did. If we when that route, we were going to mount two outdoor box speakers to the bimini frame with plug connectors so we could take them down. Being under the bimini would also keep them protected from UV. The second option we considered was mounting the speakers inside the companion way - one near the top on each side. The speakers would be mounted on brackets that would allow us to aim them toward the cockpit and toward the interior, depending on where we wanted the sound. Ultimately, we scraped both these ideas and wound up mounting box speakers in the cabin. The two forward speakers are mounted near the bulkhead separating the saloon from the v-berth, and are aimed aft. We have found that this produces plenty of sound in the cockpit, and has the added benefit of keeping the sound directed only toward us rather than every boat around us. We also thought about combing boxes, like you mention, but ultimately decided we did not want to give up the storage space.|
|03-18-2010 08:16 AM|
Thanks for the feedback. SD was right about the binnacle comment.
I found some box speakers that will fit in my jib sheet/winch handle storage cut outs (is there a name for these?) in my cockpit. I'm thinking that may be a better solution. I have two concerns with that layout. One, the speakers will be facing each other across a narrow cockpit. I think if I angle them slightly toward the front this should not be an issue. Second, they will likely take some abuse from winch handles and jib sheets.
On the positive side they will be fairly well protected from the elements and other than screws and holes for wires no additional holes in the fiberglass.
|03-17-2010 12:06 PM|
Originally Posted by Capnblu View Post
|03-17-2010 11:48 AM|
|Capnblu||I like that Idea CD, do you have another pair forward?|
|03-17-2010 11:16 AM|
Here is a pic of them mounted under our seat.
|03-17-2010 11:12 AM|
I have used Polyplanar. Sound is not great, but we are 4-5 years and going. THey are mounted under my seats on the stern rail.
Use a good watertight connector. Should you mount them near a rail, you can run them through the rails and minimize UV on the wires.
The better speakers (oh... that Camaraderie were here) are the Bose outside speakers. I thought they had a better sound. We had those on our previous boat a the same location and they worked without incident for 3 years. I sold the boat not long after that so I can only guess tehy are still working??
PS I cannot imagine sailing without cockpit speakers. Really makes things enjoyable and drowneds out things like, "Brian.... could you go check on the kids???"
|03-17-2010 10:13 AM|
Another worry is if the speakers are mounted in an area that opens to the bilge. If the boat gets pooped, will water get into the hull that way? If the space opens to the bilge, it would be wise to mount the speakers under deck plates that can be closed off in bad weather.
As for the binnacle, I believe the OP is referring to the distance the compass will be from the speakers, since it is mounted on a binnacle... not that the binnacle would shield the compass.
Originally Posted by Groven View Post
|This thread has more than 10 replies. Click here to review the whole thread.|