|Topic Review (Newest First)|
|05-08-2006 07:34 PM|
sounds like something's binding
I never had to use a winch to furl my 400 sq.ft. 110 jib on my 38' Irwin ,with a schaefer roller furler. Never tried it on the genny, Here in Corpus Christi, the wind is seldom light enough to mess with running a larger sail.
|05-08-2006 07:12 PM|
Originally Posted by Faster
|05-08-2006 04:24 PM|
|LyleRussell||If you have an adjustable backstay easing it will help rolling up the sail. For sure if you need a winch something is wrong. Try eyeballing the roller at the top that the halyard attaches to. Is the halyard wrapping the headstay?|
|04-27-2006 12:45 AM|
Good points, Sailingdog, hadn't considered the non braided cores.
In our case we used the thinner, stronger line and covered it with stripped out cover to improve the "hand" and to give the stoppers/cleats something to grab.
Can also visualize the core-less cover rolling up flat on the furling drum - compact and perhaps less potential for overrides?!?
|04-26-2006 11:02 PM|
Outer cores are safer
Originally Posted by Faster
|04-26-2006 08:28 PM|
Alado Furling Gear
Am Considering The Alado Furler For My 29 Ft C&c Mark 1. Can You Give Me Any Pros And Cons About The Furler.
|04-15-2006 09:05 PM|
I've sailed on a couple of 40 footers where we used the winch routinely to furl the jib, but I never use a winch on my Beneteau 23's Furlex. Have heard of people untwisting the wire of the forestay using a winch to furl when something is binding up.
Agree whole-heartedly with the folks that say to check for something binding. I'd do some test furls dockside on a calm day. Definitely check for the halyard wrapping around the forestay. I've got the Harken roller lead on my mast to take care of that problem.
One Step Closer
Lake St. Clair, MI
|04-14-2006 08:47 AM|
Watch the backstay
I have an Alado furler on my 35' boat, and it works well enough, but it is important to remember to tension the adjustable backstay if you have one. This will stiffen the head stay and make the system work more smoothly.
|04-14-2006 02:19 AM|
You should be able to furl most modern systems by hand in most conditions. We have about a 560 sq ft headsail on a Schaffer 3100 (slightly larger drum diameter for more leverage).
It's a 41 foot sloop, and we almost always can furl by hand. It got eaven easier when we replaced the deck bullseyes that the furling line runs through, and replaced them with the Shaffer stanchion-mounted roller bearing leads.
|04-13-2006 10:49 PM|
Cover or core?
I would think that the cover was removed, leaving the stronger, thinner core to go onto the drum. Same as we did, only we stripped the core out of double braid and replaced it with the (lower stretch) kevlar line.
|This thread has more than 10 replies. Click here to review the whole thread.|