|Topic Review (Newest First)|
|05-20-2010 02:56 PM|
I installed all of our chartplotter and autopilot cables up throught the pedestal gaurd. Used a bolt with fishing line to fish the line up through the tubes and out the drilled hole. Gromet on the drilled hole. Do not forget to put rubber on the lower edges of gaurd tubes so their is no chafe when the line enters from the engine area into the pedestal gaurd. Also secure the cables so they do not swing or pull once installed.
|05-18-2010 10:18 PM|
I'd pass it through the rail as mentioned above through something as simple as a grommet. I, personally, would not get too bent out of shape about "weatherproofing" the penetration. Ensure, if your decks are cored, that the hole you make in the deck at the base of the rail is sealed from the core. However ... I wouldn't make the (ineffective) mess of installing a grommet with sealant. It's not going to work very well in this location ... simply due to the combined difficulties of the curved sealing surfaces and potential for relative motion of wire in grommet or grommet in rail if you ever bump the cable.
Any amount of water entry through this penetration would collect harmlessly in the rail foot and if it does happen to drip into the boat ... would be so minimal you might as well call it humidity. It's not going to sink your boat if you don't get a cable penetration through a pedestal rail absolutely waterproof.
|05-18-2010 09:50 PM|
As you refer indirectly above, be careful to keep the wire away from moving parts inside the pedestal...chains, cables, etc.
That said, I considered the same but found it more attractive to run up inside a guard tube then enter the instrument box without ever exposing the cable - a cleaner look and I think safer from abraision and weather. I 'hogged out' the SS tube right where the navpod box attaches and passed the AP cable into the navpod at that point. No unsightly wires.
|05-18-2010 03:12 PM|
Any time that a wire will be installed through any thing you should use chafe protection. That is the only function of the grommet. This would apply to passing the wire / cable through either your pedestal, or the pedestal guard.
If you are concerned about waterproofing, get one of these;
BTW - these are called Deck Glands
|05-18-2010 02:12 PM|
Weatherproofing isn't a problem. The grommets are good for chafe guard. Just coat the wire and grommet with a marine sealant for additional protection.
I'd be a bit concerned about passing autopilot wires thru the pedestal if they're anywhere near your compass. As you know, any current passing thru a wire creates an electromagnetic field around the wire; the strength of that field -- and the potential for mischief -- depends on several factors. You might run a test...if that's practical...before finalizing the installation.
|05-18-2010 01:17 PM|
Drill through guard or pedestal?
Couple of questions as I don't like drilling holes in boats.
Rubber Grommet Assortment Kit