|Topic Review (Newest First)|
|05-27-2010 07:10 PM|
|sailor50||You can get left hand locking nuts from C Sherman Johnson, and probably Hayn. They make a lot of lifeline fittings.|
|05-27-2010 01:53 PM|
Originally Posted by erps View Post
Many, if not the majority of pelican hook studs are left handed.
Boasun, what are the ten percent of turnbuckles that don't have both left and right hand threads?
|05-27-2010 11:20 AM|
90% of your turn buckles have both right hand & left hand thread. And finding a new locking nut for that left hand thread is nigh on to impossible.
Why you ask a turn buckle has both? Well when you are turning the barrel of said turn buckle both ends move in or out the same amount.
Inspect every turn buckle you have on your boat and you will see what I am talking about.
|05-27-2010 09:32 AM|
|erps||Don't some of the fittings have backwards threads too? You might be doing a "leftie-loosey" but tightening it up instead. Just sayin'.|
|05-27-2010 09:25 AM|
Originally Posted by knothead View Post
The saying "penny wise, pound foolish" certainly applies here. You are literally gambling with the safety of you and your crew here for a relatively inexpensive rigging job.
You can struggle with the existing stuff, and always have that nagging worry in the back of your mind about whether or not the old ones will fail.
Or you can replace the lifelines with new ones and have a secure feeling that they can be depended on to do their job -- helping to keep captain and crew aboard the boat.
Your choice, but I know which one I'd make.
|05-26-2010 09:46 PM|
|ambianceack||heat gently with propane torch to crack the rust|
|05-26-2010 08:38 PM|
|CharlieCobra||Stainless is like aluminum in that it will gall against like metal. It could be that this is your issue. Once ya get them apart, if ya get them apart, replacement is advised. Use an "anti-seize" paste when re-assembling.|
|05-26-2010 06:50 PM|
|bofus1||Bofus11 here; thanks for the replies- any more will be appreciated|
|05-25-2010 08:20 PM|
Originally Posted by bofus1 View Post
If you are just trying to adjust the pelican hooks, try spraying them for awhile, then while holding the swage stud in a pair of vise grip pliers or better yet, a vise with soft jaws, carefully start working the locknut back and forth. If you get movement, keep working it. Don't force it or it might gall or shear off.
You can use a little heat from a torch, but don't overdo it.
If you can get the lifelines off the boat, then you might want to try soaking the fittings is Ospho. It will eat the rust and clean up the stainless.
Truthfully though, if your fittings are seized up, they should be replaced.
|05-25-2010 08:08 PM|
|sailingdog||Try Kroil or PB Blaster... these are industrial grade penetrating lubricants. Be careful with them as the will attack rubber and plastic in many cases.|
|This thread has more than 10 replies. Click here to review the whole thread.|