SailNet Community - Reply to Topic
Thread: Sabre water pump Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the SailNet Community forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
Please note: After entering 3 characters a list of Usernames already in use will appear and the list will disappear once a valid Username is entered.

User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

  Additional Options
Miscellaneous Options

Click here to view the posting rules you are bound to when clicking the
'Submit Reply' button below

  Topic Review (Newest First)
06-07-2010 03:23 PM
tommays On my A4 the orginal pump was so worn out i had to buy the Moyer Marine unit and replace it

You would need to inspect the pump and look at the shaft bore (my bore had worn huge) and the wear plate the impeller runs on to make suction

Also if the cover plate and rear of the pump wear the sides of the impeller rub is worn it will not work well
06-07-2010 03:00 PM
phoxie Sorry to bring up an old thread, but I have a Sabre 28 with an Atomic in it and I replaced the impeller this spring. Started the engine yesterday and at a low rpm, there was no water going thru the engine, causing the temp gauge to rise. If I gave it a little gas, the pump would sart to draw water and cool the engine down. Back off on the gas and the water stopped.

Thoughts, comments........

04-17-2001 10:35 AM
Sabre water pump

try asking on the sabre-list e-mail group. You should get some good advice there. (just go to "join e-mail lists".
04-12-2001 11:16 AM
Sabre water pump

Remove the grease cup body using a 7/16" wrench.
Remove the four screws on the cover plate and the cover plate.
Grab the base of the impeller, not the vanes, with a needle nose plier, etc. Wiggle the impeller until it moves out of the housing (many times it can be wiggled out without removing the grease cup). The impeller is held to the shaft with a small bronze circlip.
Thats it.
Hope this helps.
04-12-2001 10:58 AM
Ark Mike
Sabre water pump

I have a 28''Sabre with a Atomic 4 engin. I need to replace the water pump impeller which is located in the lower left back corner of the motor. Can not figure out a way to get to it without pulling the motor. Does anyone have any suggestions?

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

For the best viewing experience please update your browser to Google Chrome