|Topic Review (Newest First)|
|05-22-2006 01:27 AM|
Cut Or Sand Your Plugs 1/16" Less Than The Hole Depth ,after You Apply Your Finish Sand Edges Of Plugs And Holes ,so It Wont Chip Finish,then After You Get The Trim Back In ,apply A Little Glue ,put Plug In. I Use A Padded Block Of Wood Laying Flat On Trim Tap Wood Block Lightly With Hammer.untill Flush,
|05-22-2006 12:50 AM|
Teak trim plugs and varnish
I finally removed all the trim around the hatchboards and have them at home so I can clean and re-finish. On my boat, all the trim was screwed from the front and all the screw holes had plugs in them. I want to varnish the trim pieces in the comfort (and shade) of my garage but here is the question: how do I varnish the plugs?