|Topic Review (Newest First)|
|09-23-2010 07:04 PM|
|chef2sail||oops read right over the Northfolk to Deltaville part|
|09-23-2010 04:54 PM|
Originally Posted by chef2sail View Post
|09-23-2010 04:33 PM|
Seems a little high...try Haven Harbor in Rock Hall (Mike)
Make sure you replace the forestay...no need to put a new furler around an old rod/ wire.
|09-23-2010 04:22 PM|
The rigger over at Deltaville boat yard is the only other game in town in Deltaville. I don't doubt they can do a good job but if you do use them, just get the quote in writing (I doubt even that will be less than you expect) and clearly explain to them you don't intend to pay more than that for the work discussed AND that you should be contacted BEFORE they perform any other work.
You might also talk to Schroeder's Yacht Systems. I suspect they could probably do a decent job as well.
|09-23-2010 02:06 PM|
Knothead - Thanks for all the good info. I also live in Florida on the Gulf side.
I have my boat in Virginia where two of my children live. I plan on getting the boat to Florida at some point. The price I got was
for them to do all the work because I am out of the country. I think I will just
wait till I get back and find a rigger and help him and learn something. Thanks Again
|09-23-2010 10:21 AM|
I guess business is much better up there if you are having a hard time finding a rigger to do the work. Down here in FL, especially since the oil spill, things have been extremely tight.
I would ask the riggers that you talk to how long they expect the job to take. I can't see how anyone could take more than four to five hours at the most to install a new furling system. Even factoring in the new wire.
The guy comes to the boat, eases the mainsheet and backstay and pulls the mast forward with a halyard. He pulls the clevis pin on the now slack forestay and then hooks up his gear and goes aloft. He secures the headstay/old furler with another halyard and pulls the top pin. Then he drops back down to the deck and with your help, lowers the old headstay/furler to the dock. All that should take only about a half hour to forty five minutes.
Then he measures the pin to pin length of the old stay and makes up the new one. Presumably with mechanical fittings. That should take about a half hour at the most.
Then he assembles the new furler. One and a half to two hours.
He raises the system, again with your help, goes aloft to pin it, comes down to pin the bottom and retunes the rig. Another half hour.
If you have him run the furling line and install the sail, that could take another half hour or so.
I am assuming that you aren't hiring two people. If you are not available to help and he has to provide his own assistant, that could add a considerable cost.
Either the riggers up there are making one hell of an hourly wage or they are really slow.
|09-23-2010 10:12 AM|
jib furler install
Originally Posted by midlifesailor View Post
do it. He referred me to someone else who I tried to contact but they never
got back with me, so I am still looking.
|09-23-2010 09:59 AM|
jib furler install
Originally Posted by knothead View Post
that you would be interested in installing it?
|09-22-2010 01:55 PM|
|09-22-2010 01:32 PM|
|This thread has more than 10 replies. Click here to review the whole thread.|