|Topic Review (Newest First)|
|02-04-2011 11:45 AM|
Originally Posted by sailingdog View Post
I have used a hacksaw to shave zincs and more recently, a portable band saw. That makes quick work of the job.
|02-03-2011 01:08 PM|
|02-03-2011 01:02 PM|
Originally Posted by mitiempo View Post
|02-03-2011 12:46 PM|
|mitiempo||Or cut them in half to make 2.|
|02-03-2011 12:40 PM|
|sailingdog||You could also just grind them down a bit with a belt sander.|
|02-03-2011 12:08 PM|
I have a small metal lathe, if some one needs to they can send me a few zincs and tell me how small they need them. i will turn them down to what ever size they need.
just pay shipping both ways.
|02-03-2011 06:14 AM|
|MARC2012||Are you using an egg or a donut?marc|
|02-02-2011 11:29 PM|
Originally Posted by Spiritofcuttysark View Post
|02-02-2011 11:11 PM|
Ok, I'll admit it. I usually grind down a 1" collar zinc for our shaft about once every 2 years, as needed. We only have a clearance of around 1/2" between the prop and the cutlass bearing on our old Tartan 27.
I looked into the 'drive savers' but since zincs are cheaper I keep grinding them down with: a grinding wheel, a 4-1/2" grinder and breathe zinc dust now and then.
Not much fun and there has to be a better way.
|02-02-2011 10:08 PM|
zinc annode grinding
Newly purchase older boat with 1" shaft. Need to reduce shaft collar zinc annode profile size by 4mm each side. Should this be done on lathe or other suggestions?