|Topic Review (Newest First)|
|03-12-2011 05:30 PM|
Originally Posted by dvuyxx View Post
Having said that, I hate lifeline netting. It won't interfere with your lines, but it does get in the way of everything else. Unless you have a small animal or child, I wouldn't consider it. Even then, tie the kids down and see rough weather as an opportunity to be rid of the small animals. ;-)
|03-12-2011 04:57 PM|
Put the netting anywhere you NEED the netting, just allow a small space UNDER the netting so you can adjust the fairleads easily and without having to 'reroute' the jibsheets each and every time you change the fairlead car position.
A P35 typically only has a 'top' lifeline ... so rig/tie/lash an additional 'rope'/wire about 2-3" higher than the caprail .... and 'hang' your netting between the top lifeline and the line that you run across the cap rail.
|03-12-2011 02:25 PM|
|dvuyxx||Excellent. So, were would you NOT put the netting? At the bowsprit ... Anywhere else? I keep on a mooring so I figure I'll need a holes by my forward chocks.|
|03-12-2011 02:17 PM|
David, jibs sheets should never get snarled in the safety netting. Either you are sheeting inboard of the lifelines, or you are sheeting OVER the lifelines outboard of them. You'd never run the sheets "though" the lifelines (between the lifelines and the toe rail) so there's no way for the sheets to get tangled in them.
OK, I'm sure there's SOME way but so far that's one tangle I've never seen or heard of. Don't worry about it.
|03-12-2011 01:11 PM|
In the attached pic one can (look hard) see that that there is a small space between the cap rail and the bottom of the hand made 'netting'. I needed to do this so that I can run the sheets inside the rail and also outside the rail, and especially when positioning the jib cars fore and aft to match the conditions and when flying a large spinn.
This 'netting', installed around the 'whole boat', is to keep a small dog onboard in heavy weather conditions - so it only needs to cover from the cap rail up to the middle 'wire' of the 'life lines'.
|03-12-2011 12:23 PM|
Safety Netting and Jib Sheets
Does anyone have an example of their safety netting setup? Do your jib sheets get snarled in them?