SailNet Community banner
  • SailNet is a forum community dedicated to Sailing enthusiasts. Come join the discussion about sailing, modifications, classifieds, troubleshooting, repairs, reviews, maintenance, and more!

Mac 21 rebuild

2K views 4 replies 4 participants last post by  sophie14 
#1 ·
hi i have a mac 21 and i am about to undergo a rebuild! which includes re finishing and patching and ultimately painting the hull. i have heard that one can that the boat apart (separate hull from deck) are there any opinions or recommendations on the subject?
thanx
 
#2 ·
mac rebuild

if your boat has an aluminum /rubber rubrail you can (carefully), pull out the rubber and unscrew the aluminum pieces. then you can probably cut the deck off with a sabresaw. obviously this is getting into a major rebuild and should only be done indoors. I am parting out a mac/venture 22. I have all the hard parts for sale best offer, mast, boom, keel, pop top, stanchions etc. also trailer. cleveland ohio call 4407770375 10am to 10 pm est. good luck
 
#4 ·
This is a little off subject but have you looked at the book "fix it and sail." Its about a guy that bought a Mac on the cheap and completely restored it. It's meant for anyone who is rehab'n and old trailer sailer but goes into a lot Mac specific details.
 
#5 ·
hull and deck

I wrote earlier about separating with a saw. this is wrong. I believe the deck is capped over a lip on the hull. after the rubrail is off you would have to seperate the two using a chisel etc. lots of work ad you probably do damage. most macs that need this much work end up scrapped.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top