|Topic Review (Newest First)|
|04-22-2011 01:07 AM|
Originally Posted by Gladrags1 View Post
|04-22-2011 01:01 AM|
Chef: I also tighten down on the dinghy, keeping her tight to the boat with control lines and spring lines. It's a virtual spider web! Just noting that there are great forces at work and you should not underestimate the need for robust davits.
|04-21-2011 10:57 PM|
Originally Posted by n0w0rries View Post
|04-21-2011 09:15 PM|
|n0w0rries||I paid $500 to have davits put on my 27 catalina (so my boat would be long enough to meet the minimum requirement for the slip I was renting) from the local fabricator in the marina. You might check that out.|
|04-21-2011 07:34 PM|
|PBzeer||I have Garhauer and second chef2sail's post.|
|04-21-2011 06:41 PM|
Glad...the trick is to tie the dinghy tight so it is really part of the boat. Ours doesnt swing or move at all once in place. We utilize a couple of ratcheting web straps over the dingy and stern rails with the dinghy held snug against a couple of small fenders.
It doesnt move and doesnt sqeek even in the most robust conditions.
Course in a real blow or for safetys sake we put the engine on the rail mount and hoist the dingy on the foredeck and/or deflate it.
|04-21-2011 08:05 AM|
In choosing davits, you need to think about worst case scenarios. The davits discussed here all seem ok (with the exception of the Kingston which are way too flimsy) but how will they deal with following seas that lift your dinghy and toss it to one side or the other. It happens. In weather like that, your probably best with the dinghy inboard but sometimes it's just a rough following sea and the weather isn't that bad. I suspect that conditions like I've described will bend all of the choices given (Forespars seems the strongest, most reinforced of the 3).
I would encourage you to check out Atkins and Hoyle Atkins and Hoyle Ltd. - #1 Dinghy and Tender Solutions. They aren't cheap but are extremely robust and well made. These are what we have on Mandolin and we are very satisfied. I added a couple of cross braces so I could install a solar panel or 2. They have handled conditions I described very well. I have seen others end up twisted from the cross forces of the waves in a following sea.
|04-20-2011 09:24 PM|
Garhauer here. I have the 6:1 and its a joy using them. Quality is good...service cannot be beat. Thety threw in an extra brace and cross piece on mine.
Their stuff impress me so much I bought my radar pole from them also. It comes with a detachable (2 pins) engine hoist which you can rig up on the pole in 30 seconds and dont have to have it there all the time. 6:1 purchase also makes lifting the engine an putting it on the rail a cinch when we go for long distance cruises or in the ocean.
Again the service cannot be beat and they will customize for your particular boat.
|04-20-2011 07:29 PM|
I want these one day. The second picture from the left is mounted on exactly my boat model.
I have these, with a cross bar and supports attached to the pushpit. They have been rock solid so far.
|04-20-2011 07:11 PM|
|Don0190||I got a set of St Criox folding davits a few months ago. I don't care much for them. At the time I thought the folding would be controlablen, not loose all the time. But they really are just flopping. Going to have to make a change to them.|
|This thread has more than 10 replies. Click here to review the whole thread.|