No I am not, I don't have much information about the history of the boat.
05-23-2011 04:10 PM
Certainly if it is gelcoat, and from the picture it appears to be. Are you sure the boat was painted?
05-23-2011 04:07 PM
Thanks as always, Mitiempo. So do you think a reasonable course of action is to fill and fair everywhere where I sanded too much away, and then just prep the rest with 80-grit and then prime?
05-23-2011 04:03 PM
The blue layers are colored gelcoat which is used so the crew laying up the hull can see more easily that they are wetting out the layers. The center section that is translucent has no gelcoat left on it by the looks of it. I don't think, from the picture, that there was any paint on the hull at all. The glossy white on the left and right side of the picture looks like gelcoat to me. I think you sanded way more off than necessary. It actually looks like everything you removed was gelcoat.
05-23-2011 03:40 PM
Roger that. Thanks for the input Tommays.
05-23-2011 03:35 PM
I have to think the blue was gelcoat much like my boats bottom was green gelcoat
I dont know how to tell in a picture BUT the gelcoat is much tougher than paint
05-23-2011 03:24 PM
Tommays: Sorry, I missed the 2 on there--it is 2333n that I used, which is what is recommended for Perfection.
05-23-2011 03:17 PM
Just went and tested out the longboard sander on the filling compound that has now fully cured, and it seemed to sand and fair everything pretty efficiently. Taking into account the whole hull it would/will be a bit of a job for sure, but definitely not impossible...
05-23-2011 03:16 PM
05-23-2011 03:14 PM
Tommays: any suggestion to help me identify which layer is which and where I could stop?
This thread has more than 10 replies.
Click here to review the whole thread.