I see it is a B&R rig. Shrouds too tight probably as posted by cruisingdream.
06-30-2011 02:43 PM
Thanks everyone for your assistance on this matter Dijon
06-30-2011 12:29 PM
If there is no back stay then you would have a pre bend in the mast which is required to get proper sail shape. I would check with Hunter and get the exact forestay length and measure the one you have. If a furler is installed there may be an extra clevis link at the bottom that is required when adding a furler which would make the stay to long to get the proper mast rake unless you have it shortened.
06-30-2011 12:08 PM
Thanks Brian but Hunter did not include a backstay on this model. It is a B&R rig.
06-30-2011 12:06 PM
Thanks cruisingdream for your response. 6" is also the metric for this rig.
I currently have 11'' even with no tension on the shrouds and stays. I will retention the forestay (turnbuckle already quite short) within the furler but failing that was wondering if there is a way of taking the bend out of the mast without damaging it.
06-30-2011 11:56 AM
Thanks Brian but the trailerable Hunter 25 does not have a backstay. The rigger I consulted mentioned that Hunter on this particular model did not incorporate one.
06-30-2011 11:44 AM
Most Hunters have mast pre bend the larger ones are around 6" of bend with no tension, I'm not sure how much yours should be assuming it is a B&R rig with no back stay it is probably normal. if the mast is raked too far back this is due to shrouds & stays being too long/short not the pre bend in the mast. (try a shorter turn buckle on the forstay & retension)
06-30-2011 11:35 AM
Thanks Brian but the Hunter 25 trailerable does not have a backstay. The rigger mentioned that Hunter uses proprietary tech in the mast spreader and shrouds that eliminates the need on this model.
06-30-2011 11:31 AM
I'm new to POrt Charlotte and I'm looking for a place(yard) that will haul my boat out store it and let me work on it for a few months and not want too much money. Anyone know of such a place? I wouldn't mind sailing a little ways to get there. \
06-30-2011 11:15 AM
If the forestay was slack and was tightened with tension on the backstay the forward lowers would keep the mid mast section in place but the upper half would take a set aft.
This thread has more than 10 replies.
Click here to review the whole thread.