|Topic Review (Newest First)|
|09-30-2011 02:11 PM|
Actual repair Pics....
I took wax paper and taped it to the back side for the daggerboard, then I used a plastic putty knife to mix and apply, Marine Tex epoxy, which I read is the best for this type of repair.
Then I rolled the wax paper over the edge and taped that side also. I applied some clamps to squeeze the board back together.
This took about 30 minutes once I was set up and did it all while watching tv.
The next morning I pulled off the clamps, tape and paper and presto the daggerboard looked great. It needed a little sanding but I was very, very please with the results.
All in all, I probably spent $20 in materials (Marine Tex, putty knives, 3 clamps) and about 2.0 hours in prep and putting the epoxy on. I figured that saved me about $400 in repairs.
Very cool!! Now I get to go see how it performs in the water!
|09-30-2011 02:03 PM|
Repairing a Daggerboard
I got some good advice on how to recondition an old beat up daggerboard for my NACRA 5.5. We hit a stump a few weeks ago which made the repair necessary.
I cleaned out the chipped pieces and part of the stump still wedged in the fiberglass.
Here are some pics of the damage before the repair was started.