SailNet Community - Reply to Topic
Thread: Two Bilges Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the SailNet Community forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
Please note: After entering 3 characters a list of Usernames already in use will appear and the list will disappear once a valid Username is entered.

User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

  Additional Options
Miscellaneous Options

Click here to view the posting rules you are bound to when clicking the
'Submit Reply' button below

  Topic Review (Newest First)
12-17-2011 11:19 PM
Capt Len Real boats always had limber holes so that water could find its way from fore to aft to be dealt with by bilge pump but modern plastic boats don't ever leak so it is not a problem any more.
12-17-2011 12:39 PM
columbia 10.7 Actually there is a large hole at the bottom of the bulkhead that creates the forward and isolated bilge area but this hole is glassed over. I am suspecting that it was glassed over when the tank was installed. Is it possible that the installer did not want the bottom of his aluminium tank to get wet?

Any ideas.

12-17-2011 06:24 AM
jameswilson29 Why not simply drill drain holes (not into the tanks) to connect the forward to the rear bilge?
12-17-2011 01:24 AM
columbia 10.7
Two Bilges

Hi All,

I just purchased a 1978 Columbia 10.7 which is set up for cruising. The PO added new water and fuel tanks below the cabin sole in the bilge area. The original water tank from the factory was in the bilge but the new one is bigger. Since the boat is new to me I decided it would be a good idea to clean out the bilge. I started to flush the bilge using the forward access---to my surprise the bilge filled up real quick and did not drain nor was it automatically pumped out. I then looked at the bilge from the rear access and their was almost no water. I then started to fill the bilge from the rear access and it began to pump just fine and the water level never got more that the level associated with the float switch. Going back to the forward access the water level was as I left it--about 10" deep. This implies that their are two separate bilge areas and the forward area has no way to get rid of water unless you bring in a hand pump. This seems really unusual---has anyone had experience with this kind of setup? Did the PO create this for some reason that is beyond my comprehension?

Any help or insight would be appreciated.



Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

For the best viewing experience please update your browser to Google Chrome