|Topic Review (Newest First)|
|02-01-2012 08:32 PM|
|oysterman23||thanks all. Yeah I am going to like the advantage gained with the rerouted topping lift and the additional block...the way it is rigged now aside from having to head up to make any adjustments, when I need to raise the boom much I need to hoist it on my shoulder and tie off. Since the mast will be coming down might as well add one more forward halyard and a functional windex (oh boy!) Then a few pillows and I can fancy myself ready for "cruising" as far as Bellport NY! (a couple hours east)|
|02-01-2012 07:44 PM|
port jib halyard
strb jib halyard
Basically no need to go forward unless we're doing a sail change. We do a good bit of distance racing and it's a lot easier to adjust things from the cockpit. I have 2 cabin top winches that make halyard adjustments easy.
|02-01-2012 04:31 PM|
|Barquito||Rigging a topping lift to a block at the masthead will also give you an emergency main halyard.|
|01-29-2012 10:43 PM|
No I havent... but I will and I wont hijack this thread no I wont I reeelly will not nope/ Thanks all when it warms up this minor quandary will be a great excuse to get to the boat and hangout playin with things...thats half the sport at times!
|01-29-2012 09:21 PM|
Originally Posted by oysterman23 View Post
End of hijack......
|01-29-2012 08:13 PM|
Hi Gary and Faster...yeah but this is a low aspect main with a four foot overhang from the transom which translates to a boom around 16' long I guess the simplest thing will be to reverse the topping lift to the masthead and down to the deck and back...that will have the advantage of being where all else needs to be done at reefing time. Thanks though...sometime Ill have a modern rig where a hard vang will be a very beautiful thing!
Faster your signature mentioning Monstserrat;s Cruel Sea took me back to my dad;s library and reading it when I was about 10...think I should grab a copy again...
|01-29-2012 05:23 PM|
A supporting vang will deal with that issue, something as simple as a boomkicker.
We have everything but the reef tack and clew run aft, (no topping lift) and our furling line and pole downhaul run through our SS handrails - a clever 'Nicholson' touch. Don't know why more builders don't do that.
Given that our reef lines are still dealt with at the gooseneck it would probably make more sense to leave the main halyard on the mast too, but doublehanded it's manageable as is..
|01-29-2012 05:05 PM|
|Gary M||You can also go to a rigid vang and eliminate your topping lift.|
|01-29-2012 12:16 PM|
My old boat (26 feet) had a topping lift that just ran from the top of the mast to the end of the boom, where it attached via a cleat. No adjustment offered. All I did was tie a loop into the line a couple feet from the boom and tied the end of the line to the cleat.
So, when I wanted the boom up, I just pushed the boom up and slipped the loop over cleat. When I wanted the topping lift loose I just pushed up on the boom a little and pulled the loop off the cleat. The topping lift went slack, but remained tied to the cleat.
It was just a matter of fiddling for a few minutes with where to position the loop, and where to attach to the cleat, but once set, required no further fussing.
|01-29-2012 11:54 AM|
my toppiung lift is rigged through a sheave at the mast head, down the mast to the deck and back to the cabintop clutch farm. When raising the main it's a simple matter of popping the main halyard clutch and, as the winch takes tension, popping the topping lift clutch.
|This thread has more than 10 replies. Click here to review the whole thread.|