SailNet Community - Reply to Topic
Thread: C&C 32 main halyard sheave Reply to Thread
Title:
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:
 

Register Now



In order to be able to post messages on the SailNet Community forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
Please note: After entering 3 characters a list of Usernames already in use will appear and the list will disappear once a valid Username is entered.


User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in









Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



  Additional Options
Miscellaneous Options

  Topic Review (Newest First)
02-17-2012 07:21 AM
Kiltmadoc Here's two shots. The double sheave is the aft side of the mast. Single sheave is the forward part.



02-14-2012 12:41 PM
Kiltmadoc There's an inner groove in the sheave that is supposed to accommodate the wire. It's u-shaped and about 1/4 inch across. The outer grove is for the rope. I would guess that, as the halyard transitioned from rope to wire, it got caught on the edge from the large groove to the inset smaller groove. When we took our sheaves out, they were all cut-up at this transition point. Also, it looked as if the wire had jumped its groove a few times and chewed up the outer groove. Either way, lots of sharp edges.

Another possibility: the clearance between the sheave and the box that holds it is very small. If you have a bulky bit of tape, it could have jammed as it exited the sheave box.

As far as obstructions inside the mast: You have wires for your gear into the masthead. You have 3 cross bars where the shrouds connect to the mast. It's possible that something got caught on a cross guard.

FWIW, we took our sheaves to a machine shop, had them route out the inset groove and went to all-rope halyards for about $90. Plus, that allowed them the put in a new oiled brass bearing; this made for worlds better action and easier pulling.

Our boat: 1981 C&C 32
01-09-2012 06:09 PM
jharvey1215
C&C 32 main halyard sheave

I have a 1980 C&C 32 and i tried to replace the wire main halyard this weekend. I wipped the new 5/16 line to the old 5/32 wire and taped it up and pulled to the top. The new line made it over the sheave and then in behind, but then stopped and would not go any further. Upon pulling it back down i noticed that the tape over the wire was all chewed up but the tape around the rope was fine. So my question is, is there something behind the sheave like a hole or some sort of metal gap that only 5/32 wire can pass through. Any pics of the 32 mast head or advice would be helpful. Thanks

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

 
For the best viewing experience please update your browser to Google Chrome