|Topic Review (Newest First)|
|03-31-2012 05:59 PM|
Re: mast deck hinge plate and halyard organizer plate on spirit 23
raised my mast today and with the extra plate in there i had to put some slack in the headstay and the back stay in order to conect the back stay .
i am going to have a mast crutch built would have made life way easier
|02-06-2012 09:06 PM|
Kenyon 3650 Mast Section
i installed this halyard plate this afternoon , end up only one hole lined up . i put a bolt and nut on the two plates . used a center punch to mark the 3 new holes and drilled each one . adding a bolt and nut in each new hole to keep it lined up .
used butyl tape from the sailnet tutorial to seal it .
i did get some longer bolts its a good thing because they were barley long
enough when i first started between the extra plate and the butyl tape it adds up .
will try and get a picture up soon .
|01-22-2012 12:17 PM|
i figure with taking the mast up and down there is always a chance of lossing a pin .
would rather have a spare then have to go buy one .
besides i know have 3 of the large ones and none of the small ones as it came with a jury rigged pin
|01-22-2012 11:56 AM|
|windyway||I would find it extremely unlikely that either of those pins would shear. Am I missing something? Why do you need a spare?|
|01-11-2012 11:26 PM|
mast deck hinge plate and halyard organizer plate on spirit 23
i just bought a halyard organizer plate for my spirit, 2 of the mounting holes line up perfect 2 are going to have to be redrilled . i noticed that the deck mounting plate for the mast has 2 different size holes has anyone drilled the smaller hole out to the size of the larger hole .
be able to carry one size of spares .