My Yanmar 2GM has rubber impellers in both the raw water pump and the pump that circulates the coolant through the engine. Having retrieved an errant impellor vane from the head I'd like to eliminate the potential for recurrence.
After I wrote my initial inquiry, I found that the Vetus strainer is only designed to operate to 55C; I'm unsure of the coolth temperature at that point in the system but it's probably less.
I also wrote the Jabsco help desk who responded, "We don't recommend installing filters in cooling discharge lines as they may cause a restriction in flow and create an additional point of potential failure in the system."
05-16-2012 08:41 AM
05-16-2012 06:27 AM
Re: Strainer between pump and engine?
Normally the cooling fluid of the engine is circulated with a centrifugal pump which does not have rubber parts.
05-16-2012 05:30 AM
Strainer between pump and engine?
I'm have a closed cooling system with a heat exchanger and am considering a small Vetus strainer inline on the discharge side of the coolth pump (not the raw water pump), The idea would be to catch any fragments of a failed impeller before they get to the engine. Do any of you do this? Is there a superior solution?