Did you ever find a supplier for this bushing? I ordered one from Ted Irwin 4 years ago. It was not made of Delrin. It looked like it was made from epoxy and it required quite a bit of trial and error shaving before the strap would fit over it, and eventually be remounted. This one needs to be replaced again. I do full time charter work so it gets alot of wear and tear.
10-27-2006 12:39 PM
Irwin Rudder Bushing
I have a 43 foot 1987 Irwin Center Cockpit and need to replace the rudder bushing. I would like to know where this part might be found since it is, I believe, a one of a kind part for Irwin Yachts. Thanks.